rocketscream / MiniUltraPro
Mini Ultra Pro - Arduino Compatible 32-bit ARM Cortex M0+ Board
☆19Updated 2 years ago
Alternatives and similar repositories for MiniUltraPro
Users that are interested in MiniUltraPro are comparing it to the libraries listed below
Sorting:
- Breakout board for LoRa all-in-one module CMWX1ZZABZ☆13Updated 5 years ago
- STM32F030F4P6 breakout board pcb files and example code☆14Updated 9 years ago
- Small Lora(WAN) board using an Atmega1284P chip and RFM95 module☆19Updated last year
- Open source I2C based datalogger. The bigger, better cousin to the original serial OpenLog.☆24Updated 2 years ago
- Arduino compatible single cell ultra low power LoRaWAN node☆22Updated 6 years ago
- Lora board with Arduino nano compatibile pinout and simple battery management☆35Updated 6 years ago
- Hardware of Jasper's Electronic Load R2☆21Updated 6 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- Backplane to connect an iC880A-SPI concentrator board to a Raspberry Pi, with protection against reversed power supply and voltage spikes…☆15Updated 5 years ago
- ☆19Updated 6 years ago
- Documentation for Generic Node☆9Updated last year
- Every thing about ESP32☆21Updated 6 years ago
- Arduino library and example code for RFToy -- an Arduino-compatible gadget for RF modules. Check http://rftoy.rayshobby.net.☆32Updated 10 years ago
- A miniature SAM21G Breakout, in the form factor/pin-out of a Pro Mini.☆42Updated 2 years ago
- Arduino port for ATSAMR34 microcontrollers. The ATSAMR34J18B is a SAML21J18B with internal SX1276 LoRa tranceiver☆11Updated 4 years ago
- Rocket Scream KiCad Library☆19Updated 9 years ago
- Featherwing for ATM90E26 Energy Monitor for use with Adafruit Feather series of boards, particularly the Huzzah (ESP8266)☆9Updated 7 years ago
- C.H.I.P. Computer RN2483 or RFM95 Lora Shield☆12Updated 8 years ago
- Open Source Reflow Oven Controller.☆19Updated 3 years ago
- nordic semiconductor wireless chipsets related code☆43Updated 10 years ago
- SAMD21 Development Board with LoRa and GPS☆36Updated 6 years ago
- http://www.adafruit.com/products/746☆27Updated 3 years ago
- An ESP8266 based Gateway for sending LORA transmissions to the Habitat high altitude balloon tracking system.☆26Updated 7 years ago
- Home logging station☆12Updated 3 years ago
- 1-channel gateway based on ESP8266 mcu☆34Updated 7 years ago
- "IoT Made Easy!" - Control SAM R34 or WLR089U0 Module with ASCII command set over UART☆19Updated 3 years ago
- Hardware for the Pi In The Sky Project☆14Updated 8 years ago
- ☆24Updated 9 years ago
- LoRa IOT Home Environment Monitoring System☆12Updated 8 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 4 years ago