Alternatives and similar repositories for Raspberry-Pi-PPS-Client

Users that are interested in Raspberry-Pi-PPS-Client are comparing it to the libraries listed below

• rascol / PPS-Client
  ☆41Updated 3 years ago
• twteamware / raspberrypi-ptp
  How to run IEEE-1588 on RaspberryPi hardware
  ☆84Updated 6 years ago
• beta-tester / RPi-GPS-PPS-StratumOne
  setup a Raspberry Pi as a Stratum One time server (GPS with PPS)
  ☆152Updated 10 months ago
• jclark / rpi-cm4-ptp-guide
  Guide to using the hardware PTP support in the Raspberry Pi CM4 and CM5
  ☆149Updated 6 months ago
• mayeranalytics / pyUBX
  Python library for parsing/generating u-blox UBX protocol messages, and for creating parsers/generators in other languages.
  ☆90Updated 4 years ago
• u-blox / ublox-C099_F9P-uCS
  ☆63Updated 5 years ago
• septentrio-gnss / uBloxCorrectionsWithSeptentrio
  ☆13Updated last year
• sparkfun / SparkFun_RTK_Firmware
  Centimeter precision GPS/GNSS using L1/L2 signals broadcast over Bluetooth SPP (using the ESP32) in an easy to use enclosure.
  ☆101Updated 2 weeks ago
• tridge / pyUblox
  python Ublox module
  ☆105Updated 2 years ago
• Korving-F / ublox
  Python library for the UBX protocol
  ☆37Updated 5 years ago
• misterpeee / balena-gps-ntpsecd
  GPS Based (Stratum 1) - NTP Server Running on Balena
  ☆19Updated last year
• philcrump / stm32-ntp-server
  Firmware for Stratum 1 NTP Server using uBlox M8 GNSS Receiver and STM32F429ZI Nucleo Development Board
  ☆32Updated 5 years ago
• dalymople / ubxtranslator
  A simple python parser for UBX messages
  ☆26Updated last year
• ddrown / teensy-ntp
  Teensy 4.1 based NTP server
  ☆38Updated 3 months ago
• mlichvar / pps-gpio-poll
  GPIO polling PPS client for Linux
  ☆17Updated 3 years ago
• sparkfun / SparkFun_Ublox_Arduino_Library
  Library to control UBX binary protocol and NMEA over I2C on Ublox GPS modules
  ☆147Updated 4 years ago
• philrandal / gpsctl
  GPS control and configuration for U-Blox GPS on Raspberry Pi 3B...
  ☆51Updated last year
• hcwinsemius / RTK_GNSS
  Manual for RTK GNSS with low cost u-blox ZED-F9P receivers rover-base setup
  ☆61Updated last year
• sparkfun / SparkFun_RTK_Facet
  The hardware and enclosure for the popular centimeter level RTK Facet GNSS receiver with built in display.
  ☆21Updated last year
• sparkfun / Qwiic_GPS-RTK2
  A breakout board for the ZED-F9P GNSS RTK capable module from u-blox.
  ☆57Updated 2 years ago
• taroz / TouchRTKStation
  Single-Frequency RTK-GNSS Rover/Base Station based on RTKLIB
  ☆95Updated 6 years ago
• linuxonly1993 / gpsd_pps
  NTP time with GPSD and PPS-enabled GPS device
  ☆36Updated 5 years ago
• commschamp / cc.ublox.commsdsl
  CommsDSL schema-based definition of UBLOX protocol
  ☆43Updated 6 months ago
• vasimv / rtkzedf9p
  Simple utility to enable internal RTK mode in Ublox ZED-F9P GPS receiver with RTKLIB-compatible output
  ☆14Updated 6 years ago
• ardusimple / simpleRTK2B
  Useful code to work with Ardusimple simpleRTK2B application board
  ☆37Updated 3 years ago
• emlid / ntripbrowser
  CLI tool to easily get NTRIP caster information
  ☆33Updated 4 months ago
• superjax / UBLOX_read
  A C++ driver to read UBLOX packets
  ☆19Updated 5 years ago
• semuconsulting / pygnssutils
  Python GNSS CLI utility library for reading, parsing and broadcasting NMEA, UBX, SBF, QGC, RTCM3, NTRIP and SPARTN protocols
  ☆126Updated 2 weeks ago
• mazgch / hpg
  This project demonstrates a full RTK solution with built in correction services.
  ☆104Updated last week
• semuconsulting / pynmeagps
  Python library for parsing and generating NMEA 0183 GNSS/GPS protocol messages.
  ☆98Updated last week