pumanzor / arduino-stuff
Misc sketch for Arduino boards
☆11Updated 5 years ago
Alternatives and similar repositories for arduino-stuff:
Users that are interested in arduino-stuff are comparing it to the libraries listed below
- Arduino controler for a closed-loop stepper motor☆86Updated 10 years ago
- RAMPS Servo Board. Replaces the X and Y stepper drivers on a RAMPS CNC control board with two channel DC motor quadrature encoder control…☆21Updated 7 years ago
- A single channel step/direction/enable/endstop to DC quadrature encoder converter. Uses an L298N DC motor driver stacked on standoffs as …☆17Updated 7 years ago
- Arduino Library to control R/C ESC's☆61Updated last year
- Modified Marlin for parallel SCARA printers.☆21Updated 12 years ago
- ESP32 port of JJRobots brilliant B-ROBOT_EVO2☆58Updated 3 years ago
- Servotor32 - Open-Source, Low-Cost USB 32 Servo Controller☆39Updated 8 years ago
- 2D actuator☆27Updated 5 years ago
- ☆45Updated 6 years ago
- Making DIY servo gimbal with 3-servo motor, MPU6050 GYRO sensor and Powered with Arduino UNO☆39Updated 8 years ago
- G-code enabled firmware for Robot Arms☆32Updated 3 years ago
- It is compatible with standard stepper motor diver, cnc or GRBL shield, direct replacement of X-Y stepper motors.☆26Updated 5 years ago
- Marlin-based Laser Cutter/Engraver firmware for RepRap Hardware ( Marlin 1.0.0 )☆29Updated 8 years ago
- Marlin firmware modified and configured for LMN's buildlog.net inspired lasercutter☆52Updated 9 years ago
- Arduino quadrature encoder library. Implements a simple to use, interrupt driven quadrature decoder for Arduino.☆33Updated 6 years ago
- ☆54Updated last year
- This is just a good faith sharing of the files used for the original prototype of the RepRap HELIOS. I am furiously working to fix all i…☆29Updated 7 years ago
- Probe Wizard for Mach3☆30Updated 5 years ago
- Arduino sketch to turn step / direction signals into DC servo motor position control - 'stepper simulator'☆19Updated 10 years ago
- This Arduino sketch expands the SBUS using an Arduino such as a small Ardiono Nano or ProMicro making the full 16 channels available on y…☆26Updated 3 years ago
- Nextion Touch Screen => NodeJS => NanoDLP By Mango3D☆79Updated 6 years ago
- GUI for grbl.☆51Updated 7 years ago
- Micro Robot Arm with ESP32 and 28BY-48 12V steppers☆81Updated 5 years ago
- Inventables X-Carve specific Grbl versions:☆44Updated 5 years ago
- M Prime One is an open, low cost and easy to use 3D printer☆67Updated 8 years ago
- Closed loop servo control for stepper motors☆10Updated 9 years ago
- This is the Arduino version of the code for my balancing robot/segway☆75Updated 11 years ago
- Various small Arduino sketches☆24Updated 6 years ago
- An Arduino 2.4GHz and IR remote controller☆35Updated 7 years ago
- Firmware for 3 Phase BLDC controller☆41Updated 4 years ago