pierre-muth / c-zero_dashboardLinks
File about a dashboard gauge for en Electric Car
☆21Updated 3 years ago
Alternatives and similar repositories for c-zero_dashboard
Users that are interested in c-zero_dashboard are comparing it to the libraries listed below
Sorting:
- Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display☆34Updated last year
- Arduino-based battery internal resistance meter☆47Updated 8 years ago
- ☆42Updated 5 years ago
- ☆32Updated 3 years ago
- HW (pcb, schematics etc) for my projects☆27Updated 2 years ago
- Custom Turbo Boost Gauge using ESP32S3 with Round Waveshare IPS Display☆121Updated last year
- Custom dashboard in car that reads OBD2 via bluetooth☆23Updated 4 years ago
- ESP8266 based CAN-Bus Diagnostic Tool☆43Updated 4 years ago
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆28Updated 2 years ago
- Solder Reflow Plate PCB☆32Updated last year
- (de)soldering station☆28Updated 8 years ago
- ESP32 based CAN development board☆178Updated 3 years ago
- SMBUS analyzer tool using an Arduino Pro Mini for Smart Batteries that use the Smart Battery System Specification.☆30Updated 6 years ago
- ☆50Updated 8 years ago
- Arduino TPMS - Tire Pressure Monitoring System☆94Updated 3 months ago
- Small diy project to monitor the 12V car battery voltage of a vehicle in winter storage.☆28Updated 8 years ago
- UCAN is an open source USB-to-CAN interface board, based on STM32F072 and candleLight open source firmware, and supports linux/win/mac mu…☆34Updated 2 years ago
- Generates TRIAC control pulse for soft start of motors used in circular saw and other DIY tools.☆22Updated 2 years ago
- DehneEVSE - EV Type 2 Charging station☆17Updated 4 years ago
- Reflow Oven Controller with EPS32 and Webapp☆41Updated 6 years ago
- Smart Battery System for ESP☆74Updated 7 years ago
- Simple USB-C Power Delivery Tester☆39Updated 2 years ago
- Arduino Library for CAN Bed☆28Updated 4 years ago
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 4 months ago
- Open-Source firmware for the ZPB30A1 electronic load (WIP)☆51Updated 7 years ago
- Alternative firmware for USB powered soldering iron ZD-20U.☆62Updated 3 years ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆33Updated 6 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆61Updated last year
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- An Arduino based LINBUS stack and signal interceptor/injector.☆196Updated 6 years ago