openhp / ServiceDisplayLinks
The Service Display is a open source tool, that allows you to connect Valden Heat Pump Controller to get maximum available information from sensors and show it graphically.
☆16Updated 4 years ago
Alternatives and similar repositories for ServiceDisplay
Users that are interested in ServiceDisplay are comparing it to the libraries listed below
Sorting:
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- Mach3 write to Arduino UNO to view X & Y DRO and read external button via ModBus protocol☆12Updated 6 years ago
- Reflow Oven Controller with EPS32 and Webapp☆43Updated 6 years ago
- ☆11Updated last year
- I2Cwrapper is a firmware framework which helps you implement Arduino based I2C target (slave) devices for control of non-I2C hardware. Su…☆36Updated 2 years ago
- ☆63Updated 6 years ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆77Updated last year
- Reflow controller with ESP32 and TFT LCD on board.☆69Updated 6 months ago
- ☆17Updated 3 years ago
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆29Updated last month
- Arduino library for INA3221 current and voltage sensor.☆19Updated 7 months ago
- ESP8266 reflow controller☆26Updated 3 years ago
- Library for working with JBD BMS☆76Updated last year
- Brain behind the DC to DC boost converter☆22Updated last year
- Monitor the status of your Smart electric drive EV with Blynk☆28Updated 3 years ago
- The Valden Heat Pump controller is a platform to precisely control heat pumps☆151Updated 4 years ago
- Arduino Library for X9C10X series digital potentiometer.☆13Updated 4 months ago
- arduino based firmware for the imax b6 charger☆10Updated 8 years ago
- Arduino-based battery internal resistance meter☆46Updated 9 years ago
- The ultimate battery tester with ESR measurement and discharge graph. Based on an Arduino Nano and a 1602 LCD.☆62Updated last week
- Load the calibration data and provide a calibrated analog read☆44Updated last year
- Arduino library for INA226. Deprecated, see link for new library☆18Updated 7 years ago
- Thinary Development Board for Arduino☆15Updated 5 years ago
- Battery cell monitor and balancer☆36Updated 7 months ago
- DIY Power Monitor project using PZEM-004T module and ESP-12F☆18Updated 3 years ago
- ATmega32-based amplifier control module with 32-band spectrum analyzer and FM radio support☆42Updated 2 years ago
- ☆17Updated 4 years ago
- An ATTiny version of Julian Iletts PWM5 Solar Charge Controller☆50Updated 4 years ago
- ☆55Updated 2 years ago
- An open source Arduino ESP32 MPPT Charger firmware equipped with charging algorithms, WiFi, LCD menus & more!☆41Updated this week