mantonakakis1 / MegaCANLinks
Megasquirt CAN Protocol with Arduino
☆37Updated 2 years ago
Alternatives and similar repositories for MegaCAN
Users that are interested in MegaCAN are comparing it to the libraries listed below
Sorting:
- An Arduino sketch and schematic for the hardware to drive a BMW instrument cluster over CAN-BUS, KBUS and general IO lines. The firmware …☆40Updated 10 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆45Updated 3 weeks ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆94Updated 3 weeks ago
- A class to read an ISO 9141-2 port found in car diagnostic OBD-II ports.☆310Updated 8 months ago
- Speeduino compatible m5x PnP PCBs☆131Updated 2 months ago
- ☆64Updated 2 weeks ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆51Updated last year
- Raspberry Pi / Teensy based Digital Gauge Cluster☆75Updated 2 years ago
- ☆152Updated last month
- rusEFI open source lowcost CAN-bus dashboard☆19Updated last month
- ECUMaster EMU CAN Stream Reader Arduino Library☆38Updated this week
- Official Speeduino hardware designs☆235Updated last year
- Free Open Motorsports ECU☆96Updated 2 weeks ago
- ☆22Updated 3 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆51Updated last year
- BMW I/K-Bus Documentation☆122Updated 10 months ago
- ☆117Updated 2 years ago
- Official and user contributed base tunes for Speeduino installations☆41Updated 9 months ago
- EMS boards powered by Speeduino☆96Updated 2 months ago
- A node.js powered interface for E38/E39/E53 + E6x/E9x BMW vehicles (Client side)☆167Updated this week
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆39Updated 2 years ago
- Arduino sketch for CAN-BUS adapter☆111Updated 9 years ago
- A dash project for tunerstudio based on RASPBIAN☆30Updated 10 months ago
- Arduino and MCP2515 CAN bus VW Instrument Cluster Controller☆49Updated 2 years ago
- ☆38Updated 3 years ago
- ☆44Updated 3 years ago
- Firmware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆15Updated 8 months ago
- An Arduino library for reading OBD-II data from your car over CAN bus☆542Updated 3 years ago
- ☆47Updated 8 months ago
- Zero Motorcycles alternative dashboard using a tft and the canbus and an Adafruit Esp32☆15Updated 3 years ago