MagnusThome / BMW-M2-DCT-Gear-indicatorLinks
OBD2 / CAN bus to display current gear in a BMW M2 with DCT
☆29Updated last year
Alternatives and similar repositories for BMW-M2-DCT-Gear-indicator
Users that are interested in BMW-M2-DCT-Gear-indicator are comparing it to the libraries listed below
Sorting:
- DS2 K-line library for Arduino and ESP32☆48Updated 3 months ago
- Firmware for canbus boxes☆96Updated last year
- ☆42Updated 3 years ago
- OBD2 K-line Reader (ISO9141 and ISO14230) with microcontrollers like ESP32, Arduino, Raspberry PI Pico☆102Updated last month
- Arduino Uno + Seeed Studio CANBUS + BMW M57 diesel☆42Updated 3 years ago
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆115Updated 9 months ago
- BMW CANbus gateway emulator & proxy☆19Updated 4 years ago
- Volvo V50 RTI Crankshaft project☆57Updated 4 years ago
- This repo for using your Arduino with MCP2515 CAN Interface and CANHacker software☆53Updated 4 years ago
- ESP32-IDF based BLE<->ISO-TP bridge targeting Macchina A0 hardware☆38Updated 2 years ago
- VW TP 2.0 Datalogger for the ESP32☆19Updated 2 years ago
- Android CAN client☆61Updated 7 years ago
- Arduino / ESP / RPi Pico library integrating the proprietary VAG Key-Word 1281 protocol (KWP1281/KW1281)☆57Updated 8 months ago
- mcp2515 canbus module to Monitor Canbus traffic☆39Updated last year
- Jetta TDI aux display☆18Updated 5 years ago
- VAGCANLOGGER - KW1281 & VW TP 2.0☆33Updated 11 years ago
- File converter from DBC to RealDash XML☆16Updated 2 months ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆27Updated last year
- RealDash examples and technical materials☆144Updated last month
- A ESP32 based interface between CAN-bus and IoT environments.☆41Updated 2 years ago
- Arduino Due solution for adding vin-coded modules to BMW cars☆58Updated 6 years ago
- ELM327 based vehicle's CAN bus sniffer☆62Updated 6 years ago
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆111Updated 3 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆39Updated 2 months ago
- Arduino firmware for Sardine CAN (Open Source J2534 device)☆83Updated 10 years ago
- Toyota's Bean Multiplex Communication Protocol for Arduino☆54Updated 3 years ago
- Bridge between Wifi and CAN. Minimal variant of the ESP32RET. Using ESP32s3☆30Updated 9 months ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆32Updated last year
- ☆25Updated 7 years ago
- VOLVO Driver Distraction Display :)☆65Updated 3 years ago