timurrrr / RaceChronoDiyBleDeviceLinks
DIY BLE device for RaceChrono, currently supports reading data from the CAN bus
☆114Updated 3 months ago
Alternatives and similar repositories for RaceChronoDiyBleDevice
Users that are interested in RaceChronoDiyBleDevice are comparing it to the libraries listed below
Sorting:
- ☆66Updated last year
- ☆43Updated 3 years ago
- Device based on Arduino to play with VAG KWP1281☆119Updated 7 years ago
- BMW I/K-Bus Documentation☆110Updated 6 months ago
- LIN Example for CWA400☆15Updated 2 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆81Updated 11 years ago
- Arduino and MCP2515 CAN bus VW Instrument Cluster Controller☆44Updated last year
- BMW E-series dbc☆73Updated last month
- Speeduino compatible m5x PnP PCBs☆122Updated last week
- Control car instrument clusters from your computer for gaming or other purposes using ESP32☆128Updated last month
- The KWP2000 is a communications protocol used for on-board vehicle diagnostics systems (OBD) by Suzuki (SDS), Kawasaki (KDS), Yamaha (YDS…☆263Updated 2 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆84Updated last week
- ☆60Updated last week
- Arduino Uno + Seeed Studio CANBUS + BMW M57 diesel☆43Updated 3 years ago
- A class to read an ISO 9141-2 port found in car diagnostic OBD-II ports.☆289Updated 4 months ago
- CAN Reverse engineering tool for ESP32 based boards (specifically EVTV ESP32Due)☆310Updated 7 months ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆40Updated last week
- DS2 K-line library for Arduino and ESP32☆51Updated 4 months ago
- Volvo LIN bus reader☆93Updated 4 years ago
- ESP32 based steering wheel adapter for Peugeot and Citroen cars☆36Updated 5 years ago
- Arduino project to power a volvo DIM outside of the car☆42Updated last year
- Toyota's Bean Multiplex Communication Protocol for Arduino☆54Updated 3 years ago
- External information display for modern Honda motorcycles, using the HDS (diagnostic) connector on the ECU and other sensors (e.g GPS, DH…☆105Updated 2 years ago
- Arduino Due solution for adding vin-coded modules to BMW cars☆58Updated 6 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- An Arduino sketch and schematic for the hardware to drive a BMW instrument cluster over CAN-BUS, KBUS and general IO lines. The firmware …☆38Updated 9 years ago
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆113Updated 3 years ago
- RejsaRubberTrac - A wireless thermal camera for monitoring tire temperatures☆148Updated last year
- Arduino firmware for Sardine CAN (Open Source J2534 device)☆84Updated 10 years ago
- ☆43Updated 4 months ago