leech001 / HCS301Links
STM32 HAL library for reading code from HCS301 433Mhz Keeloq
☆19Updated 5 years ago
Alternatives and similar repositories for HCS301
Users that are interested in HCS301 are comparing it to the libraries listed below
Sorting:
- STM32 HAL library for reading and sending code for Radio frequency (RF) barrier (Came, Nice) simple code 12, 24 bit and HCS301 with keelo…☆30Updated 5 years ago
- HCS301 Keeloq Programming Example☆28Updated 5 years ago
- CC1101 Low-Power Sub-1 GHz RF Transceiver driver for esp-idf☆72Updated last month
- Simple packet radio on ATMEGA328p (arduino) and CC1101 chip - PC to PC communicator☆27Updated 4 years ago
- A remote control clone of an RC-switch using Arduino Nano and a TI CC1101 module☆33Updated 5 years ago
- Arduino RF rolling code keeloq receiver☆26Updated last year
- Presence detection using RTL8720DN 2.4G/5G Dual Bands Wifi Module☆40Updated 2 years ago
- ESPboy Sub1GhzScaner using CC1101 module☆34Updated last year
- With this tool, you can register entries of the CC1101 during operation read and change. You can switch to send or receive. Set the trans…☆45Updated 4 years ago
- Arduino support for SAM D|L|C (M0+ and M4F). It adds support for new devices like the D51, SAMR34, L21, C21, and D11. It also adds new cl…☆10Updated last year
- Get RF frequencies that are above the set threshold by hopping through a list of commonly used frequencies☆10Updated 2 years ago
- BW16 (RTL8720DN) Module - Getting Started with Arduino☆49Updated 4 years ago
- ESPboy RFID-NFC module for read/write/store/emulate RFID and NFC tags☆26Updated 2 years ago
- WT32-SC01-PLUS Module With SubGhz, Wifi and Bluetooth - Using CC1101, Able to play .sub files from the FlipperZero - Protocol Analysis, E…☆91Updated last year
- Arduino library for TI CC1101. Supports the latest Arduino IDE and Platformio. Tested with AVR atmega328, stm32f103, nodeMCU and probably…☆52Updated 9 months ago
- Programmer for HCS301 EEPROM Code Hopping using Arduino☆10Updated last year
- Scan 2.4Ghz Band with nRF24L01☆66Updated 3 years ago
- This is simple half duplex radio communication device built with CC1101 module and Arduino Pro Micro (3.3V / 8MHz) using SmartRC library☆20Updated 3 years ago
- Analyze frequencies using CC1101☆26Updated last year
- Band scanner with nRF24L01 and OLED display☆39Updated 6 years ago
- ☆22Updated 3 years ago
- Sending and receiving Simu: Radio motor Hz / Hz02 / EHz / Door control RSA / Radio receiver SA Hz / Garage door operator GM800 / GM1000 M…☆43Updated 4 years ago
- An open source application for programming HCS EEPROM Code Hopping. Support keeloq key generation from manufacturer code for Simple, Norm…☆24Updated 5 months ago
- Blog about my journey investigation uhf-rfid with arduino and cc1101☆50Updated 3 years ago
- Simple project w/ GPS Neo-6m and ESP32☆46Updated 2 years ago
- frequency scan and jamming☆28Updated 8 years ago
- ☆25Updated 3 years ago
- HUB repository for all the Catsniffer Firmware code available maintaned by Electronic Cats☆23Updated last week
- Nodemcu RF433 Tool☆46Updated 3 years ago
- Beacon monitor for ESP32 with OLED display☆24Updated 6 years ago