larsks / gpio-watchLinks
☆90Updated 2 years ago
Alternatives and similar repositories for gpio-watch
Users that are interested in gpio-watch are comparing it to the libraries listed below
Sorting:
- Minimal IPv6 library for Ethernet controllers on Arduino☆64Updated 4 years ago
- miZy - tiny fast embedded linux☆111Updated 6 years ago
- Linux kernel module driver for the ESP8266 chip for Raspberry Pi☆45Updated 9 years ago
- Some scripts to build and install the Realtek 8192cu driver via dkms, with concurrent mode enabled, allowing simultaneous AP and client m…☆38Updated 3 years ago
- Modular GPIO interface☆109Updated last year
- A Linux kernel SPI-driver for the RFM12B and RFM69CW RF modules by HopeRF☆114Updated 3 years ago
- C code to decode the Revision: field of /proc/cpuinfo on the Raspberry Pi☆35Updated last month
- ☆114Updated 8 years ago
- ESP8266 firmware SLIP Command, support mqtt, restful client☆83Updated 10 years ago
- The objective of this project is to provide an SDK and root file system for the Raspberry Pi that is lightweight and takes full advantage…☆231Updated 3 years ago
- Note: THIS CODE IS UNMAINTAINED. Consider switching to https://github.com/chmorgan/esphttpd instead.☆89Updated 8 years ago
- Dump the state of the BCM270x GPIOs☆122Updated 5 months ago
- OpenWrt feed containing plan44 packages☆30Updated last week
- Mirror of cc-tool from SourceForge☆166Updated last month
- Controlling different relay cards for home automation with a Linux software☆84Updated 2 years ago
- sdm120c ModBus Mini Smart Meter☆73Updated 4 years ago
- etherrape port towards IPv6☆164Updated 2 months ago
- ESPTerm - ESP8266 terminal emulator. Branches: [master] patches, [work] next release☆134Updated 7 years ago
- ESP8266 lwIP library with NAT, SLIP, ENC28j60 Ethernet, and routing support☆70Updated 5 years ago
- Linear MQTT Dashboard☆55Updated 5 years ago
- Digital Humidity, Pressure and Temperature Sensor☆36Updated 7 years ago
- Programmer for CC2538 backdoor UART bootloader☆46Updated 11 years ago
- An esp8266 rom creation tool☆63Updated 6 years ago
- The interface for a host to communicate with TI CC253X Zigbee Network Processor(ZNP) over a serial port.☆60Updated 6 years ago
- jpnevulator is a handy serial sniffer. You can use it to send data on a serial device too. You can read or write from/to one or more seri…☆123Updated 4 years ago
- Open source firmware for the xiaomi desk lamp☆111Updated 6 years ago
- Preliminary openocd Xtensa arch support for esp8266, work in progress☆41Updated 10 years ago
- ☆50Updated last year
- This is a GPIO access library for Banana Pro/Pi. It is based on the original WiringPi for Raspberry Pi.☆87Updated 6 years ago
- A protocol agnostic library for HopeRF's RFM69 modules and STM32 controllers☆68Updated 8 years ago