dashesy / cc-tool
Mirror of cc-tool from SourceForge
☆159Updated 2 years ago
Alternatives and similar repositories for cc-tool:
Users that are interested in cc-tool are comparing it to the libraries listed below
- ☆40Updated 7 years ago
- flash CC2531 USB dongle from your Raspberry, without Arduino nor CC Debugger.☆220Updated 3 years ago
- Whsniff is a command line utility that interfaces TI CC2531 USB dongle with Wireshark for capturing and displaying IEEE 802.15.4 traffic …☆136Updated 8 months ago
- An open source ZigBee gateway solution with node.js.☆250Updated 6 years ago
- A Python 3 project to implement EZSP for EmberZNet devices☆198Updated this week
- The interface for a host to communicate with TI CC253X Zigbee Network Processor(ZNP) over a serial port.☆61Updated 5 years ago
- Xiaomi BLE Temperature and Humidity Sensor Bluetooth To MQTT gateway☆142Updated last year
- Xiaomi Zigbee to MQTT bridge using zigbee-shepherd☆99Updated 6 years ago
- Programmer for CC2538 backdoor UART bootloader☆46Updated 11 years ago
- TI CC2652R w/ USB-UART in the ubiquitous "stick" form factor☆82Updated 4 years ago
- TI CC2531, CC13x2, CC26x2 radio support for Zigpy and ZHA☆152Updated 3 weeks ago
- Some nodemcu based to run sonoff wifi enabled plugs through MQTT☆46Updated 5 years ago
- ☆29Updated 3 years ago
- A BLE to MQTT bridge☆60Updated 6 years ago
- Zigbee light switch with dim support base on chip cc2530☆92Updated 4 years ago
- AqaraHub is an open-source Zigbee hub for Xiaomi Aqara devices. It aims to be a replacement to the Xiaomi Gateway that does not require c…☆257Updated 3 years ago
- ccsniffpiper☆92Updated 3 years ago
- Aqara (Xiaomi) Gateway to MQTT bridge (I use it for home assistant integration)☆89Updated 4 years ago
- An arduino library that implements the CC.Debugger protocol of TI☆178Updated 6 years ago
- ZigBee CC2538 Coordinator for direct use on the GPIO of the Raspberry Pi☆23Updated 4 years ago
- Transform a Xiaomi Zigbee gadget into a Zigbee sniffer.☆40Updated 4 years ago
- Python bindngs for the Xiaomi Mi Home zigbee hub and associated devices☆140Updated 8 years ago
- Small tool to read values from Xiaomi Mijia Bluetooth sensors and submit them to a MQTT broker☆22Updated 3 years ago
- Python cross-platform script to upload firmware via the serial boot loader onto the CC13xx, CC2538 and CC26xx SoC.☆570Updated 3 weeks ago
- Texas Instruments Z-Stack ZNP handler for zigpy☆73Updated 4 years ago
- Publish info from RTL433 receiver to MQTT broker☆95Updated 3 years ago
- Python 802.15.4 packet sniffer for the CC2531 EMK from Texas Instruments☆85Updated 3 years ago
- EZSP Firmware☆25Updated 3 years ago
- Single relay with ds18b20 sensor for TI cc2530 and Sonoff Zigbee☆63Updated last year
- Library to read data from particulate matter sensors☆21Updated 2 years ago