jukolein / NMEA0183-WindsensorLinks
DIY-Windsensor based on an ESP8266 with 3D printed enclosure
☆12Updated 4 years ago
Alternatives and similar repositories for NMEA0183-Windsensor
Users that are interested in NMEA0183-Windsensor are comparing it to the libraries listed below
Sorting:
- nmea2000 gateway with ESP32☆87Updated last month
- This repository shows how to build a NMEA2000 WiFi Gateway with voltage and temperature alarms.☆88Updated 3 years ago
- To measure temperature and barometric pressure with a BMP280 sensor and send it to NMEA2000 network.☆16Updated 2 years ago
- Getting started with the Sunton ESP32-S3 7 inch display, LovyanGFX and LVGL☆19Updated 8 months ago
- Wifi to 3x Serial bridge based on a ESP32☆90Updated last year
- Library for working with JBD BMS☆76Updated last year
- Material für den NMEA2000-Workshop.☆49Updated 6 months ago
- An Actisense NGT-1 compatible NMEA 2000 USB gateway for the SH-ESP32☆33Updated 2 years ago
- ☆63Updated 6 years ago
- Sailor Hat for ESP32 hardware☆48Updated last year
- Program for reading data from a Xiaoxiang smart BMS and printing to an OLED display☆21Updated 5 years ago
- ESP32 NTRIP Interface☆70Updated 10 months ago
- Read and Write Library for Overkill Solar BMSs☆19Updated 3 years ago
- Digital compass acting as B&G Precision 9 based on ESP32 and CMPS14☆18Updated last year
- An ATTiny version of Julian Iletts PWM5 Solar Charge Controller☆50Updated 4 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- M5Stack Tough (ESP-32) Sailing Instruments Display and Autopilot Control☆120Updated 10 months ago
- Worlds best RC servo tester? With oscilloscope and games!☆18Updated 2 years ago
- Arduino Interface for cheap 2.4ghz RF enabled Solar Micro Inverters☆66Updated 2 years ago
- To measure battery voltage, engine RPM, fuel level and exhaust teperature with an ESP32 and send it to a NMEA 2000 network.☆63Updated 3 years ago
- An open source Arduino ESP32 MPPT Charger firmware equipped with charging algorithms, WiFi, LCD menus & more!☆41Updated this week
- This repository shows how to use the M5Stack as NMEA 2000 Display and WiFi Gateway.☆43Updated 3 years ago
- ☆30Updated 3 years ago
- Universal Signal K sensor framework for the ESP32 platform☆187Updated 5 months ago
- ☆10Updated 2 years ago
- Examples of using the ULP Co-Processor of the ESP32 with simple pulse counting, which I extended for also saving the shortest pulse.☆28Updated 3 years ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆117Updated last year
- Arduino library for communicating with Daly BMSs over UART☆113Updated 2 years ago
- using an ESP32 or ESP8266 to create a smart thermostat☆145Updated last year
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆54Updated 2 years ago