brainiac27 / cwa400_linLinks
LIN Example for CWA400
☆15Updated 2 years ago
Alternatives and similar repositories for cwa400_lin
Users that are interested in cwa400_lin are comparing it to the libraries listed below
Sorting:
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆89Updated 3 weeks ago
- ☆22Updated 2 years ago
- ☆61Updated 2 weeks ago
- ☆44Updated 3 years ago
- Volvo LIN bus reader☆97Updated 4 years ago
- BMW E-series dbc☆77Updated 2 weeks ago
- Information on the BMW E65 7 Series Powertrain CAN bus☆31Updated 7 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆44Updated 2 months ago
- Arduino and MCP2515 CAN bus VW Instrument Cluster Controller☆46Updated 2 years ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆48Updated last year
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆31Updated last year
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆118Updated last year
- BMW CANbus gateway emulator & proxy☆21Updated 4 years ago
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆114Updated 3 years ago
- Arduino Uno + Seeed Studio CANBUS + BMW M57 diesel☆46Updated 4 years ago
- leaf spline revers engineering☆14Updated 5 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆49Updated last year
- ESP32 based steering wheel adapter for Peugeot and Citroen cars☆36Updated 5 years ago
- Device based on Arduino to play with VAG KWP1281☆120Updated 7 years ago
- An Arduino sketch and schematic for the hardware to drive a BMW instrument cluster over CAN-BUS, KBUS and general IO lines. The firmware …☆38Updated 10 years ago
- Arduino Due solution for adding vin-coded modules to BMW cars☆62Updated 6 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- ☆22Updated 7 years ago
- Wideband Lambda Controller with Bosch CJ125☆42Updated last year
- Arduino project to power a volvo DIM outside of the car☆43Updated 2 years ago
- A fully custom infotainment system for my W211 E55 AMG based on a PC with a custom daughter board!☆32Updated 2 months ago
- A class to read an ISO 9141-2 port found in car diagnostic OBD-II ports.☆297Updated 6 months ago
- ☆51Updated 2 years ago
- FIS Control for the masses.☆49Updated 7 years ago
- rusEFI open source lowcost CAN-bus dashboard☆17Updated 3 weeks ago