cloudn1ne / MowgliLinks
YardForce GForce Mainboard RE
☆52Updated 2 years ago
Alternatives and similar repositories for Mowgli
Users that are interested in Mowgli are comparing it to the libraries listed below
Sorting:
- YardForce GForce Mainboard RE☆20Updated last month
- Opensource firmware for Worx robotic mower model Landroid WG79X.XX☆148Updated last year
- Ardumower Sunray☆90Updated last week
- ☆103Updated last year
- ESP8266 Connector to get Daly / XENES / HI-BMS / BullTron BMS Data into MQTT systems☆174Updated 2 months ago
- ESPHome component to monitor and control a Xiaoxiang Battery Management System (JBD-BMS) via UART-TTL or BLE☆186Updated 3 weeks ago
- Controller for HmIP-VdMot actuators☆66Updated 4 months ago
- Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF☆99Updated 5 years ago
- Bresser 5-in-1/6-in-1/7-in-1 868 MHz Weather Sensor Radio Receiver for Arduino based on CC1101, SX1276/RFM95W, SX1262 or LR1121☆157Updated 3 weeks ago
- Victron Mppt charger ve.direct to esphome node☆379Updated 2 months ago
- Add Home Assistant support to your RDTech power supply☆50Updated 7 months ago
- A Python API to parse Victron Instant Readout BLE advertisements☆152Updated last week
- JBD BMS Linux utility☆68Updated 5 months ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆130Updated 4 years ago
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆93Updated 2 weeks ago
- ☆36Updated last year
- M-Bus --> MQTT-Gateway with shields for ESPs☆67Updated 3 weeks ago
- Software for an esp8266 nodemcu to read data from APS inverters.☆143Updated 2 months ago
- Develop an open source robotic lawn mower (HW+SW reference platform)☆268Updated 3 years ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆117Updated last year
- An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)☆109Updated 4 months ago
- ☆35Updated 3 months ago
- Cascaded sunray server and rover application☆33Updated 3 months ago
- Use a esp32 to push VE.Direct ASCII messages to a MQTT server☆64Updated last year
- ☆89Updated last month
- ☆167Updated last year
- Use an ESP8266 to read live-, statistical- and status-data from an EpEver LandStar (LS1024B) via Modbus and publish using MQTT☆32Updated 6 years ago
- ☆13Updated 5 months ago
- Victron bluetooth and serial communication at a python script. With MQTT and HomeAssistant support.☆132Updated 2 months ago
- Driver to embed the Chargery BMS to a Venus OS device☆33Updated last year