bqlabs / MotioSuitLinks
☆41Updated 9 years ago
Alternatives and similar repositories for MotioSuit
Users that are interested in MotioSuit are comparing it to the libraries listed below
Sorting:
- Active motion capture suit which reads data from IMUs in real time and sends them to Blender over Bluetooth. Low cost and open-source☆118Updated 9 years ago
- nRF52 code: handles LightHouse pulse signals measured with TS4231 + IMU☆58Updated 5 years ago
- BNO055 Absolute orientation sensor board and library☆25Updated 7 years ago
- Firmware for the NearZero Brushless Motor Controller☆46Updated 5 years ago
- Arduino and Processng library to interface with the HTC Vive Lighthouse beacons☆75Updated 8 years ago
- Inertial Motion Capture for everyone☆105Updated 2 years ago
- PCBs for a imu chain over i2c☆27Updated 7 years ago
- Organization Page☆143Updated 2 years ago
- Janus Jr is a five-bar parallel robot designed to work with brushless motors, Arduino IDE and 3D printed parts.☆22Updated 4 years ago
- Lighthouse Sensor for HTC Vive☆41Updated 8 years ago
- Official Triton Guide:☆41Updated 4 years ago
- ST's new smaller, lower-power 9-axis motion sensor☆41Updated 4 years ago
- Open source low cost inertial motion capture system.☆104Updated 7 years ago
- Digitally fabricatable machines using low-friction tape for sliding surfaces☆16Updated 7 years ago
- an open multi-touch tracker based on mutual capacitance sensing☆48Updated 5 years ago
- Open-source DIY parametric robot☆62Updated 5 years ago
- UVC (USB Video Class) using teensy☆24Updated 11 years ago
- Sixi Robot Arm☆23Updated 6 years ago
- VCM Actuator (Open Source Design)☆36Updated last year
- Arduino Library for Swept Frequency Capacitive Sensing using passive components and hardware timers.☆35Updated 9 years ago
- ☆37Updated 5 years ago
- Controller that drives BLDC motor as servo☆10Updated 5 years ago
- Small program to generate base station geometry for vive-diy-position-sensor project☆26Updated 5 years ago
- Script to control a robotic arm with the mouse from Blender, which sends the corresponding IK angles over serial port.☆54Updated 9 years ago
- DO NOT USE THIS PROJECT - WILL BE SUPERCEDED☆17Updated 7 years ago
- Arduino STM32. Hardware files to support STM32 boards, on Arduino IDE 1.6.x including LeafLabs Maple and other generic STM32F103 boards☆15Updated 8 years ago
- Completely open-source, reverse-engineered implementation of a tracked device for the SteamVR virtual reality system.☆60Updated 7 years ago
- ☆42Updated 3 months ago
- A simple editor for ESP code that runs inside the PDE☆20Updated 8 years ago
- DC Motor Controller with CAN Interface. CC-BY 4.0☆13Updated 6 years ago