blanu / codec2-arduinoLinks
A proof-of-concept for running the Codec2 audio codec on an Arduino-compatible Adafruit Feather nRF52 Bluefruit LE board
☆32Updated 8 years ago
Alternatives and similar repositories for codec2-arduino
Users that are interested in codec2-arduino are comparing it to the libraries listed below
Sorting:
- Codec2 Walkie Talkie☆68Updated 8 years ago
- General purpose firmware for MicroModem with forward error correction and larger packet sizes☆65Updated 7 years ago
- EFR32-based handheld transceiver☆63Updated last year
- Codec2 low bit rate audio codec Arduino library for ESP32☆24Updated 2 years ago
- Walkie-talkie using digital voice transmission☆32Updated last year
- Si4463 Radio Library for AVR and Arduino☆80Updated last year
- RDA1846 VHF/UHF Transceiver Chip I2C library for Arduino☆64Updated 7 years ago
- APRS with DRA818 module☆29Updated last month
- using stm32f4-discovery with SX1262 for voice☆35Updated last year
- Radio beacon for VHF/UHF/SHF bands. Disciplined by GPS, WSPR and PI4 protocol ready. QRP 5W output power.☆24Updated 8 years ago
- Arduino library for DRA818 VHF/UHF Band Voice Transceiver☆49Updated 2 years ago
- 1.5-3GHz RF down-converter for RTL-SDR☆39Updated 8 years ago
- Updated ubitx☆29Updated 4 years ago
- AX5043 Based USB Radio, dual band UHF and VHF☆32Updated 3 years ago
- LNA for RTL Based SDR Receivers☆44Updated 11 years ago
- Experimental software-defined radio using a serial port☆80Updated 6 years ago
- Faraday node software☆49Updated 7 years ago
- Dual channel Arduino Nano milliwatt power meter for HF/VHF/UHF/SHF bands☆27Updated last year
- MAX2871 based RF Signal Generator in an Adafruit Feather Form Factor☆49Updated 5 years ago
- Codec2 library for ESP32 (Arduino)☆80Updated 3 years ago
- RF power detector board design files☆19Updated 9 years ago
- A SDR PCB project base on msi2500 and msi001☆61Updated 4 years ago
- This library is used to connect CC2500 RF Module (Texas Instruments) with Arduino. This library is tested on Arduino UNO.☆45Updated 11 years ago
- Complete stand-alone WSPR2 transmitter using ESP32 + Si5351 modules. Uses SNTP for transmit time-sync☆31Updated last year
- A lightweight APRS tracker and digipeater☆35Updated 6 years ago
- Breakout PCB design and STM32F0 firmware for the Rafael R820T2 tuner chip☆80Updated 7 years ago
- ☆42Updated 3 years ago
- LimeSDR-Mini board FPGA project☆63Updated 3 years ago
- CDM324 Amplification Backpack, With Case and Simulations☆62Updated 8 years ago
- VNA software with an Arduino☆38Updated 7 years ago