WiseLabCMU / rpi-poe-hatLinks
Raspberry Pi Power-over-Ethernet (POE) Hat: Power your RPi and connect it to Ethernet using a single RJ45 cat5 cable
☆27Updated 8 years ago
Alternatives and similar repositories for rpi-poe-hat
Users that are interested in rpi-poe-hat are comparing it to the libraries listed below
Sorting:
- ☆127Updated 4 years ago
- ☆204Updated 2 years ago
- Schematic symbols and footprint for Raspberry Pi Compute Module 4 for KiCad☆51Updated 4 years ago
- ☆72Updated 3 years ago
- Raspberry Pi CM4 bindings for JDI LT070ME05000 1200x1920 IPS display☆80Updated 4 years ago
- ☆12Updated 4 years ago
- Smallest, yet feature rich baseboard for Raspberry Pi Compute Module 4☆165Updated 4 years ago
- Raspberry Pi Compute Module 4 micro carrier board☆39Updated 4 years ago
- This is simple carrier board for your CM4☆75Updated 2 years ago
- Design files and schematic for Piunora☆52Updated last year
- ESP32-S2 IoT developement board with WiFi, USB programmer, RGB LED, LiPo charger, GPIOs☆16Updated 5 years ago
- CH330 breakout board☆26Updated 2 years ago
- Anotter USB temperature logger that can record up to four channels with thermocouple or NTCs connected via CDC directly or SCPI to USB.☆63Updated 2 years ago
- PicoBerry - small CM4 carrier board with full 40-pin GPIO header☆63Updated 3 years ago
- The hardware for the Raspberry Pi Zero power over Ethernet devices☆45Updated 9 years ago
- A very minimal design to break out some common peripherals of the CM4. More a quick demonstration than anything else.☆125Updated 4 years ago
- Code and libraries to use a FLIR Lepton Thermal Imaging Camera Module☆195Updated last year
- KiCad design files for various Raspberry Pi Compute Module 4 (CM4) carrier boards.☆114Updated 4 years ago
- Convert your KiCAD board into a nice looking 2D drawing suitable for pinout diagrams☆13Updated last year
- Power Over Ethernet Internet of Things POE IoT board with Espressif ESP32 WiFi, Bluetooth and wired 100Mbit Ethehernet with 25W power del…☆27Updated last week
- Development board for ESP32-P4 Dual core RISCV processor from Espressif☆34Updated 3 weeks ago
- Provisioning system for CM4 products☆116Updated last year
- Semi-automatic passive printable/castable feeder for LitePlacer☆59Updated 5 years ago
- New Raspberry Pi Compute Module 4 Eagle Library and 3D Models☆38Updated 2 years ago
- An open-source TTL UART <-> RS485 converter, intended for a Raspberry Pi or Arduino☆41Updated 4 years ago
- ☆17Updated 9 years ago
- Neopixel protocol decoder for Saleae Logic Analyzer☆22Updated 7 years ago
- Open Source Hardware Test/Programming Fixture☆115Updated 5 years ago
- Autonomous USB-C PD controller for Power Sink applications (from Vbus=5V to 20V)☆124Updated 3 years ago
- Frequency Counter library for the RP2040 under the Arduino IDE.☆23Updated 2 years ago