Alternatives and similar repositories for PoEPi-hardware

Users that are interested in PoEPi-hardware are comparing it to the libraries listed below

• xorbit / LiFePO4wered-Pi
  Access library, command line tool and daemon for the LiFePO4wered/Pi module
  ☆134Updated 2 years ago
• jerome-labidurie / d1_mini_kicad
  Kicad footrpints and templates for wemos D1 mini board
  ☆86Updated 8 months ago
• Miceuz / i2c-moisture-sensor
  I2C based soil moisture sensor
  ☆247Updated 2 years ago
• lambcutlet / DPS5005_pyGUI
  A python gui to display & control DPS5005 power supply
  ☆78Updated 2 years ago
• MarcelMG / DIY-Soldering-Station-Controller
  A soldering station controller compatible with Weller RT tips
  ☆42Updated 5 years ago
• engineertype / ControLeo2
  Software for the ControLeo2 Reflow Oven controller
  ☆57Updated 8 years ago
• rfinnie / rdserialtool
  rdserialtool - RDTech UM/DPS/RD series device interface tool
  ☆99Updated 3 years ago
• apollo-ng / picoReflow
  Turns a Raspberry Pi into a universal, web enabled Reflow Oven Controller
  ☆207Updated 2 years ago
• bikerglen / pixpoe
  Control and power up to 20 W of neopixels or other WS2812b LEDs over ethernet!
  ☆22Updated 5 years ago
• MalteP / espweather
  ESP8266 WiFi Weather Sensor
  ☆94Updated 5 years ago
• casanovg / timonel
  ATtiny85/45/25 I2C bootloader
  ☆113Updated 2 years ago
• jbaumann / attiny_daemon
  Hardware and Software for a Raspberry UPS based on an ATTiny
  ☆65Updated 2 years ago
• tjko / riden-flashtool
  Riden RD6006 Firmware Update Flash Tool
  ☆77Updated this week
• domgregori / huBulb
  ☆101Updated 4 years ago
• openKolibri / klais-16
  Sixteen Segment Display in the Klais range.
  ☆56Updated 4 years ago
• Petezah / roomba_wall_v2
  An AVR program for ATTiny85 to transmit a virtual wall signal for an iRobot Roomba
  ☆32Updated 4 years ago
• hallard / RAK831-Zero
  Pi Zero RAK831 Adapter board
  ☆104Updated 7 years ago
• RoGeorge / DS1054Z_screen_capture
  Capture the display of a Rigol DS1000Z series oscilloscope by LAN only, using LXI SCPI commands. No USB, no VISA, no IVI and no Rigol dri…
  ☆217Updated 2 years ago
• fredlllll / FredUtil-Arduino
  snippets that were too small for their own library
  ☆38Updated 6 years ago
• mikelawrence / RPi_Zero_pHat_Template
  KiCad template for a Raspberry Pi Zero sized uHat (micro-Hat).
  ☆80Updated 4 years ago
• 0xjmux / ESP-PROG-Adapter
  Adapter PCB and Kicad Library to make adding component-less program and debug footprints to your PCBs as easy as possible
  ☆44Updated last year
• rheslip / PyDSA
  Spectrum Analyzer for the Rigol DS1000 series oscilloscopes
  ☆135Updated 3 years ago
• 0xPIT / ESParklines
  Sparklines 📉📈 for ESP8266, ESP32 – Should work with other Arduino-supported controllers
  ☆96Updated 3 years ago
• mike-rankin / ESP_trINKet
  ☆71Updated 7 years ago
• ihartwig / PoEPi-hardware
  The hardware for the Raspberry Pi Zero power over Ethernet devices
  ☆19Updated 7 months ago
• botletics / Reflowduino
  Arduino-compatible wireless reflow oven controller ecosystem of open-source hardware
  ☆210Updated 5 years ago
• ThingPulse / espaper-weatherstation
  WeatherStation for the 2.9" ESPaper modules
  ☆92Updated 3 years ago
• timonsku / Minimal-RPi-CM-4-Carrier
  A very minimal design to break out some common peripherals of the CM4. More a quick demonstration than anything else.
  ☆124Updated 4 years ago
• alvarop / chaac
  ☆21Updated 7 months ago
• ArduinoHannover / ZPB30A1_Firmware
  Open-Source firmware for the ZPB30A1 electronic load (WIP)
  ☆50Updated 7 years ago