IRNAS / IoT-battery-packLinks
PiRA - Power in Responsive Applications (IoT battery pack) developed for seamless use with a number of applications, primarily Safecast Soalrcast unit
☆11Updated 7 years ago
Alternatives and similar repositories for IoT-battery-pack
Users that are interested in IoT-battery-pack are comparing it to the libraries listed below
Sorting:
- PiRA - Power in Responsive Applications HAT for Raspberry Pi Zero with RTC for power saving mode.☆11Updated 7 years ago
- Demonstration application for LoRa Edge tracker reference design - compatible with LoRa Basics Modem☆13Updated last year
- Raspberry PI Lora Gateway/Node for RFM92/95/96/98/69HCW Modules☆62Updated 9 years ago
- A LoRa to BLE relay in 2 versions based on the new SX1262 chipset and an nRF52840. It can run Meshtastic already☆18Updated 5 years ago
- An IO-PCB (two motor-driver/H-bridge, CAN, RS232, ADS1115, relay, ethernet, ardusimple f9p compatible connector) with an ESP32 for 12V po…☆38Updated 5 years ago
- Software Source code for LoRa_GPS_Tracker☆50Updated 3 years ago
- ESP32+RFM95 = Single-channel LoRa WiFI Gateway (or device!)☆30Updated 2 years ago
- CDM324 Amplification Backpack, With Case and Simulations☆61Updated 8 years ago
- The hardware and enclosure for the popular centimeter level RTK Facet GNSS receiver with built in display.☆22Updated 11 months ago
- Easy LoRaWAN is an up-to-10km wireless platform to monitor and control smart farms, factories and buildings.☆12Updated 3 weeks ago
- Documentation, firmware and hardware specification of the Eawag/ZHAW development "A Synchronous LoRa-based Mesh Network"☆13Updated 4 years ago
- PLDuino controller's repository for code, docs and other related stuff.☆28Updated 6 years ago
- Open source mPCIe LoRa® concentrators from Nebra☆20Updated 3 years ago
- Arduino libraries for Iono Uno, Iono MKR, and Iono RP☆23Updated 2 years ago
- Test Code for IC Station CDM324 24ghz Microwave Radar Switch☆27Updated 5 years ago
- LoRa HAB Repeater☆41Updated 6 years ago
- Small Lora(WAN) board using an Atmega1284P chip and RFM95 module☆20Updated last year
- foxBMS Hardware☆11Updated 7 years ago
- A python script to receive Single Edge Nibble Transmission (SENT) protocol using python and the Raspberry Pi Zero☆23Updated 4 years ago
- SAMD21 Development Board with LoRa and GPS☆36Updated 6 years ago
- Symbols and Footprints for CadSoft Eagle☆29Updated 6 years ago
- SunLeaf is a WiFi based remote sensor module, interfaces with I2C and UART sensors, pushes directly to the cloud.☆22Updated 8 years ago
- HW and FW of a TinyGS 2.4 GHz LoRa ground station https://tinygs.com/☆27Updated 4 months ago
- Sensything is an ESP32-based IoT device that has multiple sensor interfaces to read from and send data from both analog and digital senso…☆20Updated 6 years ago
- ☆11Updated 2 years ago
- AggroFox: IoT Sensing, notifications, dashboard and analytics platform for urban and large-scale agriculture,with automated irrigation, u…☆12Updated 7 years ago
- Arduino library and example code for RFToy -- an Arduino-compatible gadget for RF modules. Check http://rftoy.rayshobby.net.☆32Updated 10 years ago
- CAN bus interface for Raspberry Pi (Zero W)☆25Updated 7 years ago
- ☆36Updated 2 months ago
- Example code for RAK811 nodes with GPS on board, transmitting their coordinates in the payload of the LoRaWAN packet in a format that is …☆14Updated 3 years ago