Techstyleuk / SensESP_3_Battery_MonitorLinks
SensESP setup for monitoring 3 boat batteries
☆21Updated 2 months ago
Alternatives and similar repositories for SensESP_3_Battery_Monitor
Users that are interested in SensESP_3_Battery_Monitor are comparing it to the libraries listed below
Sorting:
- 12V camper battery monitor with low energy bluetooth readout☆31Updated last year
- Open hardware digital switching for boats☆24Updated 9 months ago
- An Actisense NGT-1 compatible NMEA 2000 USB gateway for the SH-ESP32☆32Updated last year
- esp8266 wifi-serial bridge with line oriented buffering optimised for NMEA-0183 applications☆15Updated last year
- ☆29Updated 2 months ago
- ESP82XX based connector for EPEver Solar tracker systems, control and watch Multiple devices over webinterface and MQTT☆59Updated last month
- Victron BlueSmart IP22 Charger ve.direct interface☆26Updated last year
- A node red based dashboard for most EPEver/EPSolar solar charge controllers.☆68Updated last year
- ☆33Updated last year
- Read and Write Library for Overkill Solar BMSs☆19Updated 2 years ago
- Web based autopilot control using ESP32 and Seatalk1☆10Updated 4 years ago
- ☆17Updated 3 years ago
- An ESP32-based controller to control MaxxFan and Houghton air conditioner using ESPHome and Home Assistant☆29Updated 4 months ago
- Read data from victron mppt and transport to mqtt server☆42Updated 3 years ago
- Contains an Arduino project for Espressif ESP32 that will run a web server with web sockets to display data from a Victron MPPT charge co…☆27Updated 4 years ago
- Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF☆98Updated 4 years ago
- Library for working with JBD BMS☆74Updated last year
- Just the Arduino Library for Overkill Solar BMSs☆37Updated 2 years ago
- YardForce GForce Mainboard RE☆20Updated last month
- ☆47Updated 2 years ago
- Examples of using the ULP Co-Processor of the ESP32 with simple pulse counting, which I extended for also saving the shortest pulse.☆27Updated 3 years ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆113Updated 11 months ago
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆43Updated last year
- ☆30Updated 3 years ago
- Use an ESP8266 to read live-, statistical- and status-data from an EpEver LandStar (LS1024B) via Modbus and publish using MQTT☆32Updated 6 years ago
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆74Updated 11 months ago
- To measure battery voltage, engine RPM, fuel level and exhaust teperature with an ESP32 and send it to a NMEA 2000 network.☆63Updated 3 years ago
- ☆129Updated 2 months ago
- Simple remote status display for Victron photovoltaic systems (Cerbo GX) without cloud access (for off-grid off-internet environment)☆12Updated 3 months ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆129Updated 3 years ago