OpenCleanEnergy / OpenMI
Open source grid-tied photovoltaic micro-inverter
☆38Updated 8 months ago
Alternatives and similar repositories for OpenMI:
Users that are interested in OpenMI are comparing it to the libraries listed below
- An open hardware platform for experimenting with DC-to-AC conversion, power and energy metering and grid tie inverters.☆64Updated 11 months ago
- Supporting documentation and software for the MPPT Solar Charger☆147Updated last year
- MPPT charge controller with HS load switch and CAN bus☆82Updated 3 years ago
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆53Updated last year
- Arduino library for communicating with Daly BMSs over UART☆95Updated last year
- An open source Arduino ESP32 MPPT Charger firmware equipped with charging algorithms, WiFi, LCD menus & more!☆31Updated 3 weeks ago
- ☆34Updated last year
- MPPT solar charge controller with dual USB ports☆60Updated 2 years ago
- wMbus receiver based on STM32L476 Nucleo and Hope RF95☆15Updated 7 years ago
- Variable Frequency Drive for ATmega328 based Arduinos☆77Updated 6 years ago
- Eagle schematics of inverter main board, sensor boards and gate drivers☆63Updated 2 years ago
- Solar/Wind MPPT charge controller for DIN rail mounting☆15Updated 4 years ago
- ARCHIVE: Lebowski controller IC 2.A1 source code and (short) explanation☆18Updated 4 years ago
- Battery management system for up to 15 Li-ion cells using bq76940 or bq76930☆69Updated 2 years ago
- Multi-Platform, Modular, Powerful ESC☆95Updated 9 months ago
- EV motor controller with space to have customizable electronics and be easy to repair and build.☆32Updated 2 years ago
- Green Energy is an open source pure sine wave solar inverter.☆23Updated 2 years ago
- ESP32-S3 based SimpleFOC compatible BLDC driver module☆49Updated 5 months ago
- Open Source Solar Inverter - Software, Hardware, Mechanics☆80Updated 10 months ago
- Arduino firmware for a Lithium-Ion battery charger☆38Updated 4 months ago
- ☆63Updated 3 years ago
- An open source linear power supply unit for hobbyists and professionals☆31Updated 3 years ago
- With these schematics and PCB's, it's possible to create a 230V AC 4KW inverter. The main processor is based on Arduino Nano, with help f…☆58Updated 2 years ago
- DIY Electronic load for DCDC converter characterization☆50Updated 4 years ago
- Modular UART Duplex Link: cobs, crc, flow-control and delivery guarantees on any UART port in Arduino☆26Updated 10 months ago
- A simple BLDC motor controller, and the evolution of the EasyController2☆81Updated 10 months ago
- ISL94202 & MSP430 based BMS☆40Updated 4 years ago
- An attempt to make my own GTI with acceptable output harmonics☆20Updated 4 years ago
- Main firmware of the Huebner inverter project☆168Updated last week
- Protection and charging module for 3/4/5S lithium batteries☆34Updated 2 years ago