Alternatives and similar repositories for Multislope-3I

Users that are interested in Multislope-3I are comparing it to the libraries listed below

• Floyd-Fish / Noise-Amplifier
  An ultra-low noise amplifier to measure low-noise LDO/OPA's wide band output noise, and many other interesting measurements. Referred to …
  ☆31Updated 2 years ago
• perehinik / Logic_Analyzer_PCB
  KiCad PCB project of Logic Analyzer
  ☆45Updated 5 years ago
• joeltroughton / uSMU
  Credit card-sized, USB-powered 4 quadrant source-measure unit hardware and firmware
  ☆127Updated 7 months ago
• curtisseizert / Nanovoltmeter
  A low noise nanovoltmeter design files and code
  ☆40Updated 5 months ago
• hellange / poor-mans-smu
  ☆23Updated 2 years ago
• jaromir-sukuba / nvm2
  Open source nanovoltmeter, model 2
  ☆36Updated last year
• jankae / SpectrumAnalyzer
  It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.
  ☆48Updated 6 years ago
• jankae / Signalgenerator
  5MHz to 2.1GHz RF Synthesizer with modulation capability
  ☆57Updated 3 years ago
• curtisseizert / LowFreqLNA
  A 0.01Hz-1+MHz low noise amplifier
  ☆31Updated 2 years ago
• jaromir-sukuba / J-SMU
  DIY source-measure unit
  ☆172Updated 3 years ago
• circuitvalley / mipi_dsi_bridge_fpga
  Source code of MIPI DSI Bridge Published on https://www.circuitvalley.com
  ☆114Updated last year
• probe-scope / Probe-Scope-PCB
  Main Probe Scope PCB Repo
  ☆57Updated 6 years ago
• PCB-Arts / zynq-feather
  Zynq-Feather brings the power of a Xilinx Zynq SoC (ARM + FPGA) into the compact Adafruit Feather form factor — enabling modular, high-pe…
  ☆49Updated 4 years ago
• vanbwodonk / ft2232hl-jtag-clone
  Digilent JTAG clone hardware + eeprom firmware (.bin)
  ☆72Updated 3 years ago
• macaba / Nuts
  ☆18Updated 11 months ago
• xjtuecho / AgmPill
  A low cost FPGA/CPLD dev-board based on AG1280Q48.
  ☆72Updated 7 months ago
• jankae / LCR
  Benchtop 100Hz to 200kHz LCR meter
  ☆171Updated last year
• eez-open / modular-psu-firmware
  Firmware for EEZ Bench Box 3 (BB3)
  ☆104Updated last year
• westonb / rogowski-relief
  rogowski coil current probe
  ☆213Updated 2 years ago
• diodep / ch55x_jtag
  CH55x USB to JTAG bridge
  ☆141Updated 10 months ago
• openwch / usb-jtag-spi
  Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x
  ☆121Updated 2 years ago
• emoestudio / eEEExplore-2023
  电子工程相关技术交流讨论repo-2023年限定
  ☆22Updated 2 years ago
• marcoreps / ADRmu
  ADR1000 10V standard
  ☆136Updated 8 months ago
• blueskull / CH552-JTAG
  USB-JTAG Adapter Using CH552
  ☆70Updated 4 years ago
• tom66 / scopy-fpga
  Application software for Scopy MVP: FPGA PS, PL, and microcontroller firmware
  ☆79Updated 5 years ago
• jaromir-sukuba / vm_mini
  handheld 6-digit voltohmmeter
  ☆61Updated 5 years ago
• dragonlock2 / ftdi_dumps
  FTDI EEPROM dumps for common JTAG FPGA programmers
  ☆92Updated 2 years ago
• issus / DifferentialProbe
  Open Source 250MHz Differential Oscilloscope Probe
  ☆82Updated 3 years ago
• ts-manuel / DDS-Function-Generator
  FPGA-Based DIY Function Generator
  ☆59Updated 5 years ago
• Leungfung / ebaz4205_hw
  ☆79Updated 6 years ago