JamesNewton / BOBPIDLinks
A VERY cheap, tested, working, PIC based P.I.D. PID servo controller
☆12Updated 2 months ago
Alternatives and similar repositories for BOBPID
Users that are interested in BOBPID are comparing it to the libraries listed below
Sorting:
- ☆16Updated 10 years ago
- Porting the great SMC3 servo motor controller by Elm Chan to an ATmega328☆17Updated 6 years ago
- tape puller/remover for 0816 automatic feeder☆21Updated 5 years ago
- Files concering PAIND PNP Feeder☆23Updated 7 years ago
- Position control of DC motors☆12Updated 5 years ago
- Closed loop servo control for stepper motors☆10Updated 9 years ago
- Pick and place 3d printable feeder☆17Updated 8 years ago
- Solder Paste Dispenser☆18Updated 10 years ago
- Virtuino library for ESP8266 and ESP32 boards☆7Updated 5 years ago
- Build a basic Servo motor DC with Encoder and Blue pill, Step, Dir, Enable☆12Updated 6 years ago
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated 7 months ago
- An universal power block based on triac. In essence this is a solid state relay with some bells and whistles☆50Updated 5 years ago
- LowPower Arduino Countdown Timer☆11Updated 4 years ago
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆25Updated last year
- ☆17Updated 10 years ago
- Mach3 write to Arduino UNO to view X & Y DRO and read external button via ModBus protocol☆11Updated 5 years ago
- This motor driver is designed to be interfaced from a host microcontroller by I2C and be able to control the motor with a PID autonomousl…☆33Updated 2 years ago
- CNC breakout for STM324F411 and ST32F446 development boards☆21Updated 2 years ago
- Firmware for the 0816 automatic 3d printed smt feeder for OpenPnP.☆34Updated 2 years ago
- converting a wiper motor into a strong servo motor☆13Updated 2 years ago
- Arduino based universal motor controller☆23Updated 4 years ago
- IoTuz driver for ESP32 based LCA 2017 IoTuz board, also can be used as a demo on an espressif WROVER☆30Updated 7 years ago
- A CNC controller to use and test Grbl_ESP32☆77Updated 4 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- Use a Nano to control the flow of energy from a Solar panel to a battery!☆18Updated 5 years ago
- Low-cost and simple GRBLHAL to MACH3 BOB bridge for Raspberry Pi Pico☆27Updated 3 months ago
- Automatic SMT Tape Feeder by Pham Thang☆19Updated 7 years ago
- This repo contains all the files of my Arduino Nano based Reflow Oven PID Controller for reflow smd soldering.☆17Updated last year
- An Arduino library for the AS5600 magnetic encoder☆35Updated 3 years ago
- STM32 driven ARM Grbl firmware☆23Updated 5 years ago