paukstelis / dcservo
Position control of DC motors
☆12Updated 5 years ago
Alternatives and similar repositories for dcservo:
Users that are interested in dcservo are comparing it to the libraries listed below
- Build a basic Servo motor DC with Encoder and Blue pill, Step, Dir, Enable☆11Updated 5 years ago
- A VERY cheap, tested, working, PIC based P.I.D. PID servo controller☆12Updated 2 months ago
- Porting the great SMC3 servo motor controller by Elm Chan to an ATmega328☆16Updated 5 years ago
- Arduino library for closed loop control of a stepper motor with an encoder.☆19Updated 5 years ago
- ☆17Updated 4 years ago
- A CNC controller to use and test Grbl_ESP32☆75Updated 4 years ago
- ☆54Updated last year
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆72Updated 8 months ago
- Probe Wizard for Mach3☆30Updated 5 years ago
- A DIY Mach4 MPG Handwheel (for controlling a CNC Machine) using an ESP32 development kit.☆14Updated 4 months ago
- 4 axis CNC, 3D, Laser Controller☆59Updated 2 months ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆48Updated 3 years ago
- MKS SERVO57B is 3d printer closed loop stepper motor NEMA23 MKS SERVO57 developed by Makerbase that prevents losing steps. CPU is STM32F1…☆21Updated 3 years ago
- Arduino based THC that read plasma cutter voltage and send Up and Down signals to Plasma Torch Actuator to adjust voltage to target value…☆42Updated 3 years ago
- Offline grbl for STM32F103C8T6 BLUE PILL (>64K)☆10Updated 3 years ago
- External step generator and IO interface for LinuxCNC over Ethernet with dual-core ESP32 and W5500 modules.☆19Updated 8 months ago
- Closed loop servo control for stepper motors☆10Updated 8 years ago
- ESP3D Firmware for ESP32 based TFT☆42Updated last month
- PCB design for 3D printer controller using ESP32 processor☆12Updated 3 years ago
- tape puller/remover for 0816 automatic feeder☆21Updated 5 years ago
- Multiple compiled versions for different boards & machines (under releases)☆58Updated 2 years ago
- The source code for the Arduino DRO linear scale interface.☆11Updated 3 years ago
- CNC Base for Blue Pill☆16Updated 5 years ago
- A Grbl_ESP32CNC Controller for MPCNC☆87Updated 2 years ago
- An Arduino library for the AS5600 magnetic encoder☆35Updated 2 years ago
- Offline controller for CNC with GRBL 1.1☆66Updated 4 years ago
- ☆45Updated 6 years ago
- Low-cost and simple GRBLHAL to MACH3 BOB bridge for Raspberry Pi Pico☆26Updated 9 months ago
- Firmware for the 0816 automatic 3d printed smt feeder for OpenPnP.☆33Updated 2 years ago
- The G-EDM is a 4in1 electrical discharge machine that supports sinker EDM, EDM engraving, EDM drilling and Wire EDM operations. In the fu…☆47Updated 5 months ago