DaveBlackH / MazdaRX8ArduinoLinks
This code runs on an Arduino device, and is designed to run as a replacement for the ECU in a Mazda Mark 1 RX8. There are many variations that appear to need tweaking from RX8 to RX8, I have documented those that I am aware of.
☆51Updated 4 years ago
Alternatives and similar repositories for MazdaRX8Arduino
Users that are interested in MazdaRX8Arduino are comparing it to the libraries listed below
Sorting:
- Arduino Due solution for adding vin-coded modules to BMW cars☆58Updated 6 years ago
- Open source engine tuning software for Mazda platforms.☆106Updated 4 years ago
- utility to dump the Mazda RX8 (and maybe others) ECU firmware☆31Updated 2 years ago
- DIY Macchina A0 Clone☆47Updated 3 years ago
- J2534 drivers for various Macchina hardware☆100Updated 2 years ago
- Tool for plotting ME7 (VCDS, ECUx, ME7L) logs☆54Updated 8 months ago
- Tool to assist in tuning simos ECUs.☆48Updated 3 years ago
- Minimalist PCM Flash Toolkit for the 2006-2015 Mazda MX-5 (NC)☆61Updated 4 years ago
- MegaTunix Tuning software for MegaSquirt (and others) EFI Controllers☆55Updated 7 years ago
- Car ECU logs processing: MAF scaling/rescaling, Table rescaling, Throttle Maps, Load / Injector Pulse Width / IAT compensation, Speed Den…☆77Updated last year
- Free Open Motorsports ECU☆83Updated last week
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆113Updated 3 years ago
- Open Source CanBUS J2534 Honda/Acura Reflash Tool (Work in Progress)☆61Updated 3 years ago
- Standalone ECU designed for Speeduino firmware☆39Updated 5 years ago
- Collection of LS Based Engine Bins and the Required XDFs for TunerPro☆98Updated 2 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆33Updated last year
- Repository for Engine Tune information☆64Updated 3 years ago
- Arduino firmware for Sardine CAN (Open Source J2534 device)☆84Updated 10 years ago
- Bosch ME7.3H4 RomTool for Ferrari 360's☆37Updated 6 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆84Updated 2 weeks ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆45Updated last year
- This project has moved to https://github.com/PcmHammer/PcmHammer/☆180Updated 5 months ago
- The best way to share your FOME, Speeduino and rusEFI tunes and logs☆64Updated last year
- BMW CANBUS/DBUS/IBUS/KBUS information/reference/examples☆58Updated 6 years ago
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆116Updated 10 months ago
- ☆15Updated 4 years ago
- J2534 CANbus Sniffing Utility☆29Updated 3 months ago
- Wideband Lambda Controller with Bosch CJ125☆41Updated last year
- A project to work on updating the checksums of Volvo ME7 BIN files.☆11Updated 4 years ago
- Volkswagen Audi Group CANBus diagnostic and ECU firmware flashing☆35Updated 8 years ago