Alternatives and similar repositories for rx8-ecu-dump

Users that are interested in rx8-ecu-dump are comparing it to the libraries listed below

• bri3d / a2l2xdf
  Convert ASAP2 A2L files to TunerPro XDF files
  ☆39Updated 2 years ago
• MotorMouth93 / BMW-XDFs
  ☆21Updated 2 years ago
• bahnz / BMW-6HPxx-XDF
  TunerPro definition file for BMW 6HPxx transmissions.
  ☆24Updated 8 years ago
• zarboz / BMW-XDFs
  ☆104Updated 2 years ago
• damienmaguire / BMW-E65-CANBUS
  Information on the BMW E65 7 Series Powertrain CAN bus
  ☆30Updated 6 years ago
• michaeldove / vagtuner
  Volkswagen Audi Group CANBus diagnostic and ECU firmware flashing
  ☆36Updated 8 years ago
• DaveBlackH / MazdaRX8Arduino
  This code runs on an Arduino device, and is designed to run as a replacement for the ECU in a Mazda Mark 1 RX8. There are many variation…
  ☆51Updated 4 years ago
• vimsh / mafscaling
  Car ECU logs processing: MAF scaling/rescaling, Table rescaling, Throttle Maps, Load / Injector Pulse Width / IAT compensation, Speed Den…
  ☆75Updated last year
• Switchleg1 / BinToolz
  Do stuff with binz and such.
  ☆25Updated 6 months ago
• beyerch / J2534DotNet
  A .Net interface for J2534 vehicle communications.
  ☆21Updated 13 years ago
• bouletmarc / HondaReflashTool
  Open Source CanBUS J2534 Honda/Acura Reflash Tool (Work in Progress)
  ☆57Updated 3 years ago
• joeyoravec / j2534-logger
  Debugging library for PassThru Vehicle Reprogramming (SAE J2534)
  ☆23Updated 6 years ago
• bri3d / TC1791_CAN_BSL
  CAN Bootstrap Loader (BSL) for Tricore AudoMAX (TC1791 and friends), including arbitrary read/write as well as compressed read functional…
  ☆65Updated 3 years ago
• Snoman002 / Engine-Tune-Repository-TunerPro-EFIlive-TunerCat
  Repository for Engine Tune information
  ☆63Updated 3 years ago
• prj / C167BoostControl
  ☆15Updated 4 years ago
• jakka351 / J2534OBD2
  J2534 OBD2 Protocol Tool
  ☆13Updated 5 months ago
• corygrant / CANBoard_HW
  Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.
  ☆37Updated 2 months ago
• turboat / eepromtool
  ☆49Updated 2 years ago
• Switchleg1 / SimosTools
  Tool to assist in tuning simos ECUs.
  ☆46Updated 3 years ago
• ElDominio / CANforVAGME75
  CANBUS implementation for ME7.5 with Arduino Nano and MCP2515
  ☆20Updated 6 years ago
• kmalinich / node-bmw-ref
  BMW CANBUS/DBUS/IBUS/KBUS information/reference/examples
  ☆59Updated 6 years ago
• nyetwurk / ecuxplot
  Tool for plotting ME7 (VCDS, ECUx, ME7L) logs
  ☆53Updated 6 months ago
• keyhana / c166-ghidra-module
  Infineon C166 Processor Module for Ghidra
  ☆26Updated 3 months ago
• Switchleg1 / AMAleg
  DIY Macchina A0 Clone
  ☆47Updated 3 years ago
• fanyi3315 / bosch-med17-block-reader
  Decode blocks out of a Bosch MED17 ECU internal flash / EEPROM dump
  ☆18Updated 5 years ago
• Skylakc / BoschME7.5-Tools
  This repository contains some useful tools related to BOSCH ME7.5 ECUs
  ☆13Updated 2 years ago
• saildot4k / MSS54-XDFs
  MSS54 and MSS54HP XDFs
  ☆79Updated 3 years ago
• HeinrichG-V12 / E65_ReverseEngineering
  ☆42Updated 3 years ago
• an-ven / VW-Instrument-Cluster-Controller
  Arduino and MCP2515 CAN bus VW Instrument Cluster Controller
  ☆41Updated last year
• fenugrec / npkern
  Nissan / Infiniti ECU reflashing kernel, for use with nisprog
  ☆50Updated 7 months ago