wuxx / PDTrickerLinks
☆33Updated 3 months ago
Alternatives and similar repositories for PDTricker
Users that are interested in PDTricker are comparing it to the libraries listed below
Sorting:
- a cheap CMSIS-DAP debugger by an WCH chip named CH549F☆47Updated 4 years ago
- An Open-Source CMSIS-DAP Debug Probe based on DAPLink and USB bus convert and it can realize USB convert to serial interface based in CH5…☆95Updated last year
- Main Probe Scope PCB Repo☆57Updated 6 years ago
- CMSIS-DAP compliant debugging probe with SWD, JTAG, and VCP support☆36Updated 2 months ago
- SFP module test board for Raspberry Pi Pico☆58Updated last year
- ICN6211 Configurator☆39Updated 5 years ago
- A minimum development board for CH32V203G6.☆44Updated 2 years ago
- Software JTAG probe running on stm32f103.☆26Updated 5 years ago
- KiCad PCB project of Logic Analyzer☆43Updated 4 years ago
- x-cube-usb-pd STM32 Expansion Package related to USB-IF Type-C Power Delivery protocol is no more recommended for new design. The USB pow…☆56Updated last year
- USB-JTAG Adapter Using CH552☆70Updated 3 years ago
- A clone of the ST-Link V2.1 with the VCP+MSD+SWO features available.☆70Updated 4 years ago
- ☆34Updated 2 years ago
- A low cost FPGA/CPLD dev-board based on AG1280Q48.☆67Updated 2 months ago
- 2.5kV Isolator for the USB Power Rail☆52Updated 2 years ago
- CMSIS-DAP compliant SWD Programmer☆24Updated last year
- Prototype project to build an underwater sensor node, powered by and communicating with the surface via Single Pair Ethernet (10BASE-T1L …☆26Updated last year
- Firmware for EEZ Bench Box 3 (BB3)☆101Updated last year
- USB-Blaster instance on CH55x MCU.☆50Updated 6 years ago
- Use gpio to emulate usb low-speed on stm32f030f4p6.Use internal rc instead of crystal.☆35Updated 8 years ago
- ☆39Updated last year
- ESC(Electronic Speed Controller) source code based on RISC-V CH32☆37Updated last year
- KiCad Library for m.2 NGFF card☆28Updated 6 years ago
- 32-bit RISC-V MCU CH32X035 built-in USB PD PHY☆64Updated 5 months ago
- USB-C 1-60V Current and Voltage Controlled Power Supply☆18Updated 3 years ago
- CM4 compatible MCU board☆33Updated last year
- Stlink Bootloaders☆13Updated 5 years ago
- WCH-LinkW is a wired/wireless 2.4G dual imitation real debugger, which can be used for online debugging and downloading of WCH RISC-V a…☆20Updated last year
- The whole NFC solution (source code and schematic&layout) based on WCH chips☆44Updated 2 years ago
- high precision voltage, current, temperature meter and logger.☆43Updated 2 years ago