wash4all / open-turbidimeter-projectLinks
A low-cost, open-source device to measure water quality.
☆19Updated 8 years ago
Alternatives and similar repositories for open-turbidimeter-project
Users that are interested in open-turbidimeter-project are comparing it to the libraries listed below
Sorting:
- Arduino Code to communicate and measure AAS Telaire Sensors☆19Updated 4 years ago
- A breakout and development board for the ESP8266 WiFi SoC.☆42Updated 5 years ago
- An open source python, flask, socketio, js web application for monitoring and control☆17Updated 10 years ago
- Live dataflow programming for microcontrollers and embedded☆218Updated 5 years ago
- A solar optimized lipoly charger☆52Updated 6 years ago
- OpenEnergyMonitor Open Source Hardware☆95Updated 6 years ago
- SquareWear is an open-source wearable electronics controller board. This repository contains the hardware design files, software library,…☆37Updated 8 years ago
- E-Paper Badge with Teensy LC designed in KiCad☆37Updated 3 years ago
- Firmware and Board Designs for the AllPixel LED Controller Board: Please direct questions and support requests to https://forum.maniacall…☆55Updated 5 years ago
- Schematic of Onion Omega2 Docks and Expansions☆92Updated 5 years ago
- TCP/IP (RF24Ethernet) and RF24Network Gateway☆51Updated 4 months ago
- SunLeaf is a WiFi based remote sensor module, interfaces with I2C and UART sensors, pushes directly to the cloud.☆22Updated 8 years ago
- ☆10Updated 7 years ago
- Small Lora(WAN) board using an Atmega1284P chip and RFM95 module☆20Updated last year
- 1 in² AC power meter☆55Updated 5 years ago
- Open Source Indoor Air Quality Monitor HAT for Raspberry Pi☆17Updated 7 years ago
- Arduino library supports many HC-SR04 sensors via I2C bus and hardware interrupt☆27Updated 8 years ago
- Python on Simba.☆62Updated 5 years ago
- Building Management and Control system☆109Updated 2 years ago
- ecDB, Electronics Component DataBase☆57Updated last year
- Better IoT Principles☆21Updated 6 years ago
- Jupyter kernel to interact with a MicroPython or CircuitPython board over its serial REPL.☆27Updated 7 years ago
- ☆55Updated 7 years ago
- An open source board for load cell reading and configuration based on the HX711 and ATmega328.☆61Updated 6 years ago
- nrf51822 GCC based projects☆28Updated 6 years ago
- Windows binaries for Kst☆33Updated 6 years ago
- MPPT single-cell LiPo battery charger based on the LT3562☆34Updated 6 years ago
- ESP8266-based I2S-output WS2812(B) Driver☆51Updated 9 years ago
- Interactive air multisensor☆47Updated 6 years ago
- This is the Seeed wiki page☆59Updated 6 years ago