viktak / TPM-H370

Related projects: ⓘ

• MrGreensWorkshop / RasPiPicoSDK-PicoBiosPostCodeReader
  DIY BIOS POST Card with the Raspberry Pi Pico over the LPC bus
  ☆61Updated 2 months ago
• tvlad1234 / Pico-10BASE-T-Library
  Library which allows the Pi Pico to send UDP packets over 10BASE-T Ethernet
  ☆4Updated last year
• jeffmakes / pi-data-recovery
  Recovering data from a bricked Raspberry Pi CM4. Same method would work on other Pis / SBC's
  ☆76Updated 2 years ago
• tomverbeure / fake_parallel_printer
  Capture traffic on parallel printer port to USB
  ☆70Updated 5 months ago
• blackjetrock / postal-pico-rom-reader
  Postal Pico ROM Reader
  ☆30Updated last year
• eeucalyptus / ch32v003-usbpd
  Use the ch32v003 as a usb pd controller
  ☆32Updated 2 months ago
• boredom101 / dev-expansion-card
  Framework Laptop Expansion Card
  ☆22Updated 3 years ago
• dilshan / i2c-test-terminal
  I2C hardware test terminal/master mode emulator.
  ☆20Updated 3 years ago
• Jana-Marie / PD-Injector
  USB-PD Power/Data Splitter
  ☆65Updated 2 years ago
• ZakKemble / RPi4-PCIe-Bridge
  Raspberry Pi 4 PCIe Bridge "Chip"
  ☆70Updated last year
• Ralim / IronOS-dfu
  Minimal USB-DFU for Miniware products with OLED driver support
  ☆35Updated 3 weeks ago
• EvanKrall / pipad
  A PCB for putting a Raspberry Pi CM4 inside a 1st-generation iPad.
  ☆52Updated last year
• arnarg / f3_backplane
  Backplane PCB for Terramaster F2-221, adding NVMe SSD
  ☆23Updated 4 months ago
• mitxela / smsc
  ☆22Updated 9 months ago
• Manawyrm / ESP32_VirtualPrinter
  ESP32 emulator for LPT/parallel port printers
  ☆27Updated last year
• dosdude1 / zif-ide-ssd
  A custom-designed IDE SSD for use in any machine that utilizies a 1.8" ZIF IDE hard disk.
  ☆87Updated last year
• circuit-specialists / Hantek-2D72
  Hantek 2000 series, 2D72 firmware, tools, unbrick Hantek 2D72 and other information
  ☆33Updated 5 years ago
• kbeckmann / uart-audio
  Audio out with an FTDI UART cable
  ☆43Updated 3 years ago
• bluepylons / USB-C-3-way-splitter
  A splitter board (for making a cable splitter) for turning a 5V 3A USB power source to 3 5V 1A USB sources
  ☆27Updated last week
• jjj11x / stc_rpncalc
  Replacement RPN calculator firmware for the diyleyuan calculator.
  ☆33Updated 2 years ago
• Upcycle-Electronics / CH341A-Pro
  Retrace pics and schematic for the Cheap Black CH341A Serial Flash EEPROM BIOS Programmer
  ☆43Updated 3 years ago
• SourceArcade / flashprog
  Mirror of review.sourcearcade.org/flashprog
  ☆23Updated last week
• davidb990 / rp2040_xoc
  Extreme Overclocking on Raspberry Pi's RP2040 chip
  ☆48Updated 2 years ago
• DoganM95 / CH340C-Pcb
  CH340C based ESP32 programmer module pcb with auto- programming & reset, sponsored by PCBWay.
  ☆34Updated 4 months ago
• benjojo / qc-usb-userspace
  A userspace USB driver for the logitech quickcam express
  ☆72Updated last year
• msillano / RD6006-Super-power-supply
  A intelligent Power supply with micro control and logging, for very long test (battery cycles)
  ☆64Updated 4 years ago
• YuzukiHD / YuzukiHCC
  Ultra low cost HDMI-USB Video Acquisition (HDMI Capture Card) based on MS2109
  ☆52Updated 2 years ago
• sabogalc / KiCad-Arduino-Boards
  A collection of Arduino boards recreated from scratch in KiCad. Legacy USB connectors have been replaced with USB-C where applicable.
  ☆23Updated 3 months ago
• ZakKemble / MailboxNotifierESP
  A WiFi connected mail notifier using an ESP8285 module and Telegram
  ☆81Updated 2 years ago
• FPGA-Computer / KVM-Switch
  ☆32Updated 2 years ago