tomverbeure / fake_parallel_printerLinks
Capture traffic on parallel printer port to USB
☆83Updated last year
Alternatives and similar repositories for fake_parallel_printer
Users that are interested in fake_parallel_printer are comparing it to the libraries listed below
Sorting:
- Capture the output from a computer's parallel printer port.☆34Updated 11 months ago
- ESP32 emulator for LPT/parallel port printers☆40Updated 2 years ago
- Hackable USB-C UART RS232 Adapter☆34Updated 7 months ago
- Library which allows the Pi Pico to send UDP packets over 10BASE-T Ethernet☆10Updated 2 years ago
- ☆66Updated 4 years ago
- STM32-based ISA-over-USB-adapter☆123Updated 4 years ago
- A collection of scripts and tools for Atmel ATF150x and GAL Programmable logic devices, some of the only standing active 5V programmable …☆107Updated last month
- Notes on using TL866II Plus with minipro software on openSUSE☆59Updated 2 years ago
- RP2040/RP2350 286 PC emulator for MURMULATOR dev board☆101Updated this week
- Geoff's VT100 Terminal☆86Updated 2 years ago
- Logic chip tester including tri-state☆22Updated 5 years ago
- My DIY paper tape punch project☆24Updated 2 months ago
- Raspberry Pi Pico DIP-EEPROM Programmer☆90Updated last year
- Converts the output from an old TMS9928A Video Display Processor to drive a small TFT panel using either an SPI or a parallel interface. …☆27Updated 2 years ago
- ☆134Updated last year
- RTL8019-based ISA network card, NE2000-compatible☆117Updated 4 years ago
- Firmware, pcbs and case design for a tiny Pinball Fantasies-based video pinball table.☆46Updated last year
- Teensy 4.1 based micro computer☆39Updated 2 years ago
- Schematics of the SMART Response XE terminal☆48Updated 3 years ago
- Arduino library that supports CF Cards and PATA drives☆37Updated 4 years ago
- by NF6X. Forked from: https://gitlab.com/NF6X_Retrocomputing/8051dumper☆22Updated 3 years ago
- DIY BIOS POST Card with the Raspberry Pi Pico over the LPC bus☆78Updated last year
- Hardware to program W27C512 EEPROM or any 24/28/32 pin ROM requiring from 5V to 27V programming voltage.☆210Updated this week
- Raspberry Pi Pico Transputer Emulator☆46Updated 2 years ago
- ☆129Updated last year
- ☆27Updated 4 years ago
- USB keyboard to PS/2 / AT / XT interface converter using a Raspberry Pi Pico☆146Updated last month
- PIC32MZ based game console☆13Updated 2 months ago
- firmware change to improve resolution of a popular "1Hz-50MHz Digital LED DIY Kits Crystal Oscillator Frequency Counter Tester" sold on E…☆24Updated 4 years ago
- Open Programming Firmware for the TL866A Programmer.☆135Updated 2 years ago