thebiguno / stubbyLinks
Source Code for Stubby the Hexapod
☆36Updated 8 years ago
Alternatives and similar repositories for stubby
Users that are interested in stubby are comparing it to the libraries listed below
Sorting:
- [DEPRECATED] Modular, opensource, high performance G-code interpreter and CNC controller written in Object-Oriented C++☆38Updated 9 years ago
- (Deprecated attempt at) A Smoothie firmware port to the Smoothieboard v2 boards.☆34Updated 8 years ago
- Embedded software (firmware) for the laser system and components, including configuration files☆27Updated last year
- Hardware design for a 3 Phase BLDC controller☆57Updated 5 years ago
- Firmware for 3 Phase BLDC controller☆41Updated 5 years ago
- Controller board for wheeled robots, based on the ESP8266 with three DC motors drivers, one-cell LiPo battery charger and Wifi connectivi…☆15Updated 9 years ago
- QT Marlin setting configuration tool☆77Updated 8 years ago
- Cyclone (Circuit Cloner) is a CNC mill intended for PCB manufacturing.☆24Updated 9 years ago
- ☆46Updated 7 years ago
- Low cost servo drive for small CNC machinery☆54Updated 8 years ago
- Arduino STM32. Hardware files to support STM32 boards, on Arduino IDE 1.6.x including LeafLabs Maple and other generic STM32F103 boards☆15Updated 8 years ago
- Arduino code for STM32 microcontrollers☆61Updated 7 years ago
- ☆17Updated 10 years ago
- Mechaduino derivative which drives up to 10A, drawn using KiCad☆29Updated 6 years ago
- ☆16Updated 10 years ago
- Pick and Place head with dual nozzles☆39Updated 5 years ago
- Andy's Workshop Reflow Oven Controller☆33Updated 7 years ago
- This is a port of GRBL 1.1 to STM32F103 target☆9Updated 8 years ago
- Horus firmware for 3D Scanner Ciclop☆70Updated 9 years ago
- CAM system for hobbyists and shapeokers☆23Updated 6 years ago
- ☆11Updated 9 years ago
- Stepper motor controller based on FreeRTOS for the ESP8266.☆64Updated 8 years ago
- Files concering PAIND PNP Feeder☆23Updated 7 years ago
- Modified Marlin for parallel SCARA printers.☆21Updated 12 years ago
- ☆36Updated 9 years ago
- ☆23Updated 9 years ago
- An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Ar…☆15Updated 9 years ago
- Part Libraries for CadSoft/Autodesk Eagle☆27Updated 4 years ago
- XDisplace are a complete solution to mill, dispense solder paste and pixk and place components to a pcb in one process!☆12Updated 8 years ago
- R2C2 -- electronics for RepRap 3D printers (and others), CNC and other machines.☆35Updated 4 years ago