snarlistic / jpnevulatorLinks
jpnevulator is a handy serial sniffer. You can use it to send data on a serial device too. You can read or write from/to one or more serial devices at the same time.
☆123Updated 3 years ago
Alternatives and similar repositories for jpnevulator
Users that are interested in jpnevulator are comparing it to the libraries listed below
Sorting:
- Grabserial - python-based serial dump and timing program - good for embedded Linux development☆211Updated 3 months ago
- openembedded meta layer for the UDOO boards☆31Updated 7 years ago
- omap image builder☆159Updated this week
- libsoc: C library for interfacing with common SoC peripherals through generic kernel interfaces☆158Updated last year
- Build improvements and bugfixes on slsnif☆30Updated 3 years ago
- C-based firmware loader for STM32's serial bootloader☆93Updated 8 years ago
- A graphical serial terminal☆156Updated 7 years ago
- A Linux command-line alternative to the FTDI FTProg utility for FTDI's FT-X series☆132Updated last year
- gs_usb compatible firmware for candleLight, cantact and canable☆24Updated 6 years ago
- gsm multiplex daemon☆50Updated 6 years ago
- CLI utility for programming CP210x USB<->UART bridges☆111Updated 4 years ago
- Just a bunch of useful scripts placed under /opt/scripts/☆130Updated last year
- Microchip SAM-BA 3 - SAM Boot Assistant 3☆11Updated 6 months ago
- Null modem emulator☆347Updated 3 months ago
- Flash your BeagleBone Black via USB☆110Updated 6 years ago
- Enables GSM 0710 multiplex using n_gsm line dicipline☆58Updated 2 years ago
- Image builder☆171Updated this week
- Device tree overlay and support scripts for using most available hardware I/O on the BeagleBone without editing dts files or rebuilding t…☆129Updated 7 years ago
- A set of python scripts to create dfu files and upload them to stm32 boards☆78Updated 3 years ago
- Cross-platform STLink v2 GUI☆189Updated 5 years ago
- A Raspberry Pi / BCM2835 Software-based UART Linux device driver☆133Updated 2 years ago
- Access Dallas 1-Wire bus on your PC via low-cost USB to UART bridge.☆165Updated 8 years ago
- yahdlc - Yet Another HDLC implementation☆87Updated last year
- miscellaneous stuff / unsorted☆99Updated 9 months ago
- LoRa device driver as a kernel module☆140Updated 6 years ago
- McuOnEclipse Processor Expert Source Files and Components☆68Updated 9 months ago
- A Yocto meta-layer for BeagleBones☆71Updated this week
- Modbus tools☆37Updated 8 years ago
- Preliminary openocd Xtensa arch support for esp8266, work in progress☆41Updated 10 years ago
- USB & UART loader for i.MX5/6/7/8 series☆271Updated last year