scotthraban / octoprint-printer-connection-plugin-for-curaLinks
OctoPrint Printer Connection Plugin for Cura to allow direct printing from Cura to OctoPrint
☆24Updated 10 years ago
Alternatives and similar repositories for octoprint-printer-connection-plugin-for-cura
Users that are interested in octoprint-printer-connection-plugin-for-cura are comparing it to the libraries listed below
Sorting:
- a Cura plugin that uploads sliced gcode files directly to an OctoPrint server☆32Updated 10 years ago
- OctoPiPanel creates a simple interface on a small screen to control OctoPrint.☆80Updated 4 years ago
- Upload GCODE generated by Simplify3D to OctoPrint☆34Updated 7 years ago
- PrusaControl is an alternative user interface for Slic3r Prusa Edition☆128Updated 6 years ago
- A full-blown GUI-based slicer plugin for OctoPrint☆101Updated 10 months ago
- OctoPrint Plugin for Fusion 360☆50Updated 7 years ago
- A touch friendly interface for a small TFT module or phone☆276Updated last year
- Slic3r plugin for slicing within OctoPrint☆92Updated 2 years ago
- HTML calculator for calibrating delta 3d printers.☆25Updated 7 months ago
- A hardware remote for Octoprint controlled 3D Printers☆21Updated 6 years ago
- ☆44Updated 2 years ago
- Update to Eustathios with a little bit of HercuLien Design Changes☆110Updated 5 years ago
- Portable, Accurate, Open Source 3D Printer☆51Updated 6 years ago
- Firmware for Original Prusa i3 3D printers MK3S, MK3, MK2.5S, MK2.5 by PrusaResearch.☆31Updated 3 months ago
- 📟 MK 3D Printer Firmware for Arduino☆51Updated 8 years ago
- AstroBox allows you to control your 3D Printer wirelessly☆170Updated 3 years ago
- SkyNet3D's internal Marlin fork with Anet A8 / A6 hardware support.☆133Updated 6 years ago
- Marlin firmware instant configurator☆389Updated 6 years ago
- Pause print on GPIO sensor☆25Updated 7 years ago
- ☆47Updated 6 years ago
- A OctoPrint touch interface for TFT touch modules based on GTK+3☆173Updated 5 years ago
- Sanguino add-on for the Arduino IDE, based on http://code.google.com/p/sanguino/☆192Updated last year
- Deprecated: use http://github.com/openhardwarecoza/LaserWeb3 instead☆186Updated 9 years ago
- #VelocityPainting: patterning 3D prints by modulating the print speed☆208Updated 8 years ago
- GRBL port for RAMPS and Sanguinololu boards. Original port was done by ArSi (read description)☆85Updated 9 years ago
- Marlin3dPrinterTool is a open-source software that helps you configure and test your 3D printer.☆259Updated 2 years ago
- Open Source Delta Automatic Calibration Tool☆52Updated 7 months ago
- An arduino based adapter to drive a 20x4 line parallel or i2c panel from smoothieware☆23Updated 8 years ago
- Kossel 250 V-Slot☆40Updated 7 years ago
- RepRap version of Zelogik's core-XY 3D printer☆82Updated 5 years ago