sandy9159 / DIY-Arduino-based-Guitar-Pickup-Coil-Winder
This is mini Arduino based machine to wind guitar pickup coil.
☆44Updated 3 years ago
Alternatives and similar repositories for DIY-Arduino-based-Guitar-Pickup-Coil-Winder
Users that are interested in DIY-Arduino-based-Guitar-Pickup-Coil-Winder are comparing it to the libraries listed below
Sorting:
- This sketch allows you to create a graphic menu with the help of a rotary encoder such as the KY-040. The code was created to be used wi…☆12Updated 3 years ago
- Open-source firmware for popular cnc3018 stm32-based offline controller☆73Updated 6 months ago
- Stereo VU meter using OLED screens and AVR microcontroller☆130Updated 4 years ago
- This library enables you to use Hardware-based PWM channels on RP2040-based boards, such as Nano_RP2040_Connect, RASPBERRY_PI_PICO, with …☆82Updated 2 years ago
- A very simple menu system using an oled and rotary encoder☆54Updated last year
- A layered menu system for Arduino based on common digital rotary encoder hardware and LCD display☆26Updated 6 years ago
- A signal generator based on an ATtiny85 that generates a range of different waveforms☆32Updated 5 years ago
- Describes and end-to-end process of milling PCBs with cheap 3018 machines. Provides some helpful utilities written in Python.☆56Updated 2 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆76Updated last year
- ESP3D Firmware for ESP32 based TFT☆45Updated last month
- Simple RPM-Meter☆57Updated 2 years ago
- FX Box 3d printed guitar pedal enclosure☆18Updated last year
- ☆32Updated 4 years ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆52Updated 3 years ago
- ☆13Updated 4 years ago
- GRBL Header for a Teensy 4☆115Updated last year
- DIY 32 SMD 0402 LED Ring Light for Potentiometers and Rotary Encoders☆34Updated last year
- 2017: VS1053 Micro Midi Synthesizer: This uses the VLSI VS1053b Audio and Midi DSP chip in its real-time Midi mode. In this mode it acts …☆17Updated 4 years ago
- GRBL Offline Controller☆39Updated last year
- A Pendant for FluidNC CNC Firmware☆51Updated last month
- A CNC controller to use and test Grbl_ESP32☆76Updated 4 years ago
- An all-in-one Arduino compatible reflow controller powered by ATtiny1634R☆124Updated 3 years ago
- The EncoderTool is a library to manage and read out rotary encoders connected either directly or via multiplexers to ARM based boards. En…☆51Updated 4 months ago
- Menu system for non touch needs☆41Updated 3 months ago
- Offline controller for CNC with GRBL 1.1☆69Updated 4 years ago
- Encoders are linked to 3 common busses to save pins☆24Updated 4 years ago
- Source code and other files for reading values from digital calipers. See the project page for complete write up at http://makingstuff.in…☆37Updated 8 years ago
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 3 months ago
- SmartPendant - a way to control grblHAL based CNC machine without PC☆45Updated last month
- List of controllers supported by grblHAL☆43Updated last month