FaqT0tum / Arduino_GraphicMenu_Encoder
This sketch allows you to create a graphic menu with the help of a rotary encoder such as the KY-040. The code was created to be used with the SD1306 OLED display via the Adafruit_SD1106 and Adafruit_GFX libraries To convert the img use the online tool: http://javl.github.io/image2cpp/
☆12Updated 3 years ago
Alternatives and similar repositories for Arduino_GraphicMenu_Encoder:
Users that are interested in Arduino_GraphicMenu_Encoder are comparing it to the libraries listed below
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆48Updated 3 years ago
- A layered menu system for Arduino based on common digital rotary encoder hardware and LCD display☆25Updated 6 years ago
- Thermocouple based, ESP32 driven PID-controller software for SMD reflow soldering☆23Updated 3 years ago
- This repo contains all the files of my Arduino Nano based Reflow Oven PID Controller for reflow smd soldering.☆16Updated 9 months ago
- Pendants for controlling FluidNC CNC firmware☆36Updated 8 months ago
- Offline controller for CNC with GRBL 1.1☆68Updated 4 years ago
- ☆42Updated 4 months ago
- Offline grbl for STM32F103C8T6 BLUE PILL (>64K)☆10Updated 3 years ago
- ATmega32-based amplifier control module with 32-band spectrum analyzer and FM radio support☆39Updated last year
- Simple RPM-Meter☆55Updated 2 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆74Updated 9 months ago
- Probe Wizard for Mach3☆30Updated 5 years ago
- The source code for my reflow oven, WARNING use at your own risk. This project deals with MAINS VOLTAGES which can kill.☆22Updated 4 years ago
- Arduino Menu/UI using OLED & Rotary Encoder☆30Updated 7 years ago
- tape puller/remover for 0816 automatic feeder☆21Updated 5 years ago
- ESP3D Firmware for ESP32 based TFT☆43Updated 2 months ago
- A Pendant for FluidNC CNC Firmware☆40Updated last week
- LowPower Arduino Countdown Timer☆11Updated 4 years ago
- A DIY Mach4 MPG Handwheel (for controlling a CNC Machine) using an ESP32 development kit.☆14Updated 5 months ago
- An Easy way to Transfer data between Arduinos☆17Updated 8 months ago
- An open source, embedded, high performance CNC laser cutting and engraving controller written in optimized C that will run on a straight …☆15Updated 7 years ago
- vu-meter☆13Updated 4 years ago
- A system to control a stepper motor over DMX protocol.☆13Updated 5 years ago
- A Grbl_ESP32CNC Controller for MPCNC☆87Updated 2 years ago
- webUI optimized for 6 to 10 inch touch displays for grblHAL.☆15Updated last year
- PC Hardware Monitor with Arduino and ST7789 240x240 IPS display☆16Updated 5 years ago
- ☆25Updated 5 years ago
- GRBL Offline Controller☆35Updated last year
- SignalGeneratorSD based on AD9833 Module☆25Updated 3 years ago
- Electronic Lead Screw - By Jon Bryan☆19Updated 4 years ago