mattwach / cnc_pcb_toolsLinks
Describes and end-to-end process of milling PCBs with cheap 3018 machines. Provides some helpful utilities written in Python.
☆56Updated 2 years ago
Alternatives and similar repositories for cnc_pcb_tools
Users that are interested in cnc_pcb_tools are comparing it to the libraries listed below
Sorting:
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- Control Program for Electronic Loads XY-FZ25 and XY-FZ35☆26Updated 3 months ago
- Project Files for ESP32 Mini TV☆126Updated last year
- Source code and other files for reading values from digital calipers. See the project page for complete write up at http://makingstuff.in…☆38Updated 8 years ago
- ESP3D Firmware for ESP32 based TFT☆46Updated 3 months ago
- ESP32-S3 Thermal Sensor using an 8-bit bus☆83Updated last year
- A simple cost-effective demo, test, training, board for an oscilloscope made from a Raspberry Pi Pico☆58Updated 7 months ago
- ☆44Updated 3 years ago
- ☆77Updated last year
- Enhancing Nice-Power Bench Power Supplies with ESP8266 Connectivity☆64Updated 6 months ago
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- ☆64Updated 2 years ago
- ☆73Updated 3 years ago
- Modular UART Duplex Link: cobs, crc, flow-control and delivery guarantees on any UART port in Arduino☆27Updated last year
- Solder Reflow Plate PCB☆31Updated last year
- Connecting cheap digital calipers to Raspberry Pi and decode readings☆120Updated 4 months ago
- ESP8266 reflow controller☆24Updated 2 years ago
- Simple RPM-Meter☆57Updated 2 years ago
- Small prototype of ESP32 Reflow controller☆14Updated 3 years ago
- Arduino button debounce library for various switch types, port expanders and other 8-bit data sources. Fast and robust debounce algorithm…☆13Updated 3 years ago
- Multi Channel Configurable PID regulator on M5Stack Core☆46Updated 10 months ago
- Simple library to exchange data between the 2 cores of a Raspberry Pi Pico under Arduino IDE framework☆27Updated 2 years ago
- Multi-sensor intelligent environmental Monitor☆17Updated last year
- ☆29Updated last year
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆53Updated 4 years ago
- A very simple menu system using an oled and rotary encoder☆54Updated last year
- DIY Printed small PCB CNC for fast Prototyping☆46Updated 4 years ago
- ☆29Updated 2 months ago
- LockDownRadioControl☆47Updated this week
- Open Source LC-Meter. All documentation included.☆81Updated 3 years ago