optisimon / ft5406-capacitive-touchLinks
Raspberry Pi 7 inch touchscreen controller display hacking (with Raspberry Pi 3 as host)
☆26Updated 8 years ago
Alternatives and similar repositories for ft5406-capacitive-touch
Users that are interested in ft5406-capacitive-touch are comparing it to the libraries listed below
Sorting:
- Hardware of Jasper's Electronic Load R2☆22Updated 7 years ago
- Home logging station☆12Updated 4 years ago
- ChipCon Tiny Loader, a 1KB serial bootloader for CC1110/CC1111☆63Updated 13 years ago
- A low cost ISM radio to wifi gateway☆41Updated 5 years ago
- An inexpensive Open Source blackmagic probe compatible SWD debugger designed to be used with ARM GDB.☆34Updated 6 years ago
- ☆23Updated 9 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 5 years ago
- DroidScript for easier use of the BusPirate on your Android device.☆45Updated 8 years ago
- ☆19Updated 7 years ago
- ESP8266 based Raspberry Pi WiFi module☆25Updated 9 years ago
- Eagle scripts for LED matrix display generation☆14Updated 2 years ago
- ESP8266 with 3.5" KeDei LCD module☆43Updated 8 years ago
- The dawn of the IoP era☆18Updated 9 years ago
- Arduino (328P) based OBD port module☆33Updated 9 years ago
- USB Power monitor☆44Updated 6 years ago
- Arduino Core and Bootloader for the ATMEL SAM D21/R21 (E Variant) chips.☆29Updated 5 years ago
- NeoPixel Library that works with STM32duino. Tested with WS2812B.☆12Updated 9 years ago
- Setup and install for ARMinARM board.☆29Updated 9 years ago
- Raspberry PI bare metal☆48Updated 11 years ago
- SAMD21G18A Sensor Board☆15Updated 9 years ago
- A command-line tool to control 433MHz OOK based devices☆42Updated 6 years ago
- HackAday Cortex Kit☆18Updated 9 years ago
- Toaster oven reflow soldering controller☆27Updated 7 years ago
- LiFePO4wered/USB power module open source hardware design files☆42Updated 6 months ago
- STM32F103C8 demonstration blink program☆26Updated 9 years ago
- ESP8266-based I2S-output WS2812(B) Driver☆51Updated 9 years ago
- E-Paper Badge with Teensy LC designed in KiCad☆37Updated 4 years ago
- Fully isolated, input debounce Hat for Raspberry Pi, for up to 6 switches, relays and powered devices☆23Updated 5 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- Originally intended to be a controller for a RetroPie. A soft power controller that allows for Raspberry Pi proper shutdown. Intention is…☆22Updated 8 years ago