olegv142 / esp32-eth-serialLinks
☆12Updated 10 months ago
Alternatives and similar repositories for esp32-eth-serial
Users that are interested in esp32-eth-serial are comparing it to the libraries listed below
Sorting:
- DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.☆36Updated 3 years ago
- USB/BLE to I2C/ADC Adapter☆33Updated 2 years ago
- Dump an NVS partition binary in human readable form☆24Updated last year
- Rigol oscilloscope remote control, mainly for use with https://github.com/Ebiroll/esp32_sigrok☆24Updated 4 years ago
- UCAN is an open source USB-to-CAN interface board, based on STM32F072 and candleLight open source firmware, and supports linux/win/mac mu…☆29Updated 2 years ago
- Allows: read firmware via BLE, restore and patch the original firmware, ...☆10Updated 9 months ago
- There are now, a total of 81 hardware electronics on this catalogue for Smart Devices, A.I. enabled. Designed in Kicad, and ready to dow…☆89Updated 9 months ago
- BLE Advertisements Repeater into Ethernet TCP/IP☆19Updated last month
- A Faker for Greenworks GW and other Battery types Omega Port faking☆9Updated 3 years ago
- TLSR SWire programmer☆63Updated last month
- A feature-rich reflow Hot-Plate firmware i.e. usable for "Tim's Hot Plate" (https://www.instructables.com/Tims-Hot-Plate/)☆23Updated 2 months ago
- Hellen-One Hardware Platform for rusEFI Engine Management System☆23Updated last week
- Прошивка для контрольки на Arduino☆14Updated last year
- ESP8266 reflow controller☆24Updated 2 years ago
- Home Assistant integration using ESPHome on a different ESP32 boards with W5500 ethernet and I²C bus☆17Updated last year
- TLSR825x programmator via COM port☆36Updated 6 months ago
- ESP32 OBD-II adapter☆15Updated last year
- This tool provides a logging function that gets data on voltage, current and power consumption. Voltage input range is from 0 to 85V, Max…☆14Updated last year
- Wifi to 3x Serial bridge based on a ESP32☆77Updated 10 months ago
- Simple generic ESP32 based PCB design, ideally suited to battery use.☆28Updated 5 months ago
- ☆56Updated last week
- A ESP32 based interface between CAN-bus and IoT environments.☆41Updated 2 years ago
- ESP uploader board for programming Espressif ESP series microcontrollers☆25Updated 2 years ago
- Motorized solder paste dispenser☆27Updated 2 years ago
- ☆20Updated 3 years ago
- FireLamp in pure C with ESP-IDF and ESP32☆20Updated last year
- This is a RF signal encode and decode library that can be adapted to different protocols by specifying the timing conditions is a table. …☆38Updated 2 years ago
- Brows CAN-Frame using esp-idf☆14Updated 3 months ago
- The Service Display is a open source tool, that allows you to connect Valden Heat Pump Controller to get maximum available information fr…☆16Updated 3 years ago
- OpenBeken simulator that allows you to draw a virtual IoT device schematic and run it on Windows. Most of OpenBeken features are emulated…☆12Updated 7 months ago