MakingStuffChannel / DigitalCalipersLinks
Source code and other files for reading values from digital calipers. See the project page for complete write up at http://makingstuff.info/Projects/Digital_Calipers
☆37Updated 8 years ago
Alternatives and similar repositories for DigitalCalipers
Users that are interested in DigitalCalipers are comparing it to the libraries listed below
Sorting:
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆75Updated last year
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆52Updated 4 years ago
- Electronic Lead Screw - By Jon Bryan☆21Updated 4 years ago
- ESP32 DIY Digital Readout☆98Updated 5 years ago
- Pendants for controlling FluidNC CNC firmware☆41Updated 2 months ago
- A specifically made script for generating fully customizable knobs for making toolless hex screws☆54Updated 2 years ago
- An ESP32 project using two linear stepper motors and a burning laser diode☆60Updated 3 years ago
- ☆29Updated 3 years ago
- DIY Printed small PCB CNC for fast Prototyping☆46Updated 4 years ago
- A Grbl_ESP32CNC Controller for MPCNC☆88Updated 3 years ago
- Lixie II - Open Source Hardware files!☆41Updated 4 years ago
- 2D actuator☆28Updated 6 years ago
- Small prototype of ESP32 Reflow controller☆14Updated 3 years ago
- A simple LED driver for Remote Control Cars, Planes, Multicopters and everything in between☆33Updated 2 years ago
- ESP8266 reflow controller☆24Updated 2 years ago
- An all-in-one Arduino compatible reflow controller powered by ATtiny1634R☆125Updated 3 years ago
- A CNC controller to use and test Grbl_ESP32☆77Updated 4 years ago
- Offline controller for CNC with GRBL 1.1☆70Updated 4 years ago
- ☆19Updated last year
- ☆43Updated 4 years ago
- ☆25Updated 5 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆58Updated last year
- Solder Reflow Plate PCB☆31Updated last year
- Combining 3d printed and metal parts to build an open source motorized dslr slider.☆14Updated 2 years ago
- ☆59Updated 2 years ago
- Marlin firmware modified and configured for LMN's buildlog.net inspired lasercutter☆52Updated 9 years ago
- Adapter to use RS-232 Magellan/SpaceMouse with modern software☆43Updated 2 years ago
- Marlin Laser working version with RAMPS Generic config☆22Updated 5 years ago
- The Little Stick Welder with Big Features.☆43Updated 3 years ago
- ☆14Updated 2 years ago