luyi1888 / rv1106-mcuLinks
Tools and notes for Rockchip RISC-V MCU.
☆33Updated last year
Alternatives and similar repositories for rv1106-mcu
Users that are interested in rv1106-mcu are comparing it to the libraries listed below
Sorting:
- LR11xx chip (LR1110 / LR1120 / LR1121) and SX126x chip (SX1261 / SX1262 / SX1268) SDK☆52Updated 10 months ago
- An Open-Source CMSIS-DAP Debug Probe based on DAPLink and USB bus convert and it can realize USB convert to serial interface based in CH5…☆95Updated last year
- Linux kernel module to use ESP8089 / ESP8266 over SPI☆65Updated 5 years ago
- AIR32F103 template project for GNU Arm Embedded Toolchain☆34Updated last year
- Allwinner V3s Documentation☆58Updated 4 years ago
- Buildroot Package for F1C100s/200s☆188Updated 2 years ago
- Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x☆113Updated 2 years ago
- ESC(Electronic Speed Controller) source code based on RISC-V CH32☆38Updated last year
- NuMicro software development tools (IDE, debug adapter, configuration tools, programmer, etc.)☆67Updated last month
- MicroPython for WCH CH32V307☆37Updated 2 years ago
- USB CDC-ECM implementation for STM32F072☆73Updated 5 years ago
- In application debugger for ARM Cortex microcontrollers.☆25Updated last week
- Cherry USB stack graphical configuration tool☆52Updated 3 years ago
- ☆19Updated 9 months ago
- USB-JTAG Adapter Using CH552☆70Updated 3 years ago
- DMA-accelerated multi-UART USB CDC for STM32F072 microcontroller☆57Updated 6 years ago
- Bare metal code examples for Allwinner's F1C100S (F1C200S) SOC☆93Updated 7 months ago
- Buildroot support for Allwinner V3s/S3/S3L☆46Updated 9 months ago
- USB to dual UART / SPI / I2C / JTAG / FIFO / Bit-Bang...☆140Updated 2 years ago
- i.MX 8M Mini SOM with 2/4-GB-LPDDR4 Reference Hardware☆35Updated 3 years ago
- Command-line access to F1C100s GPIO☆24Updated 6 years ago
- The whole NFC solution (source code and schematic&layout) based on WCH chips☆44Updated 2 years ago
- Simple library for get 9V/12V/configurable output with step 0.2V from chargers with Quick Charge 2.0/3.0.☆12Updated 4 years ago
- ☆55Updated 8 years ago
- f1c100s source code☆33Updated 9 months ago
- a daplink made of pi-pico☆30Updated 3 years ago
- OpenOCD port running on ESP32-S3 microcontrollers☆80Updated 4 months ago
- Its a cheap "single board computer". Closest analogue Lichee PI.☆32Updated 4 years ago
- Driver for LLCC68 radio☆72Updated last year
- A low cost FPGA/CPLD dev-board based on AG1280Q48.☆67Updated 2 months ago