joshellissh / pi-dgcLinks
Raspberry Pi based Digital Gauge Cluster
☆49Updated 3 years ago
Alternatives and similar repositories for pi-dgc
Users that are interested in pi-dgc are comparing it to the libraries listed below
Sorting:
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆94Updated last week
- RealDash examples and technical materials☆167Updated 5 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated last year
- Raspberry Pi / Teensy based Digital Gauge Cluster☆76Updated 2 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆84Updated 12 years ago
- BMW CANBUS/DBUS/IBUS/KBUS information/reference/examples☆66Updated 7 years ago
- ☆25Updated 7 years ago
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆122Updated last year
- ☆64Updated 3 weeks ago
- FIS Control for the masses.☆51Updated 7 years ago
- ☆155Updated last month
- LIN Example for CWA400☆15Updated 2 years ago
- Arduino ODBII ELM327 Emulator - Allows Arduino to act as an OBD2 ELM327 device and responde to PID requests☆68Updated 2 years ago
- ☆22Updated 3 years ago
- Device based on Arduino to play with VAG KWP1281☆124Updated 7 years ago
- Arduino/Teensy CAN Gauges with OLED displays☆16Updated 7 years ago
- ECU designed for Speeduino firmware☆35Updated 5 years ago
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆119Updated 3 years ago
- EMS boards powered by Speeduino☆96Updated 2 months ago
- ☆44Updated 3 years ago
- microRusEfi board for rusEfi ECU☆84Updated 4 months ago
- A class to read an ISO 9141-2 port found in car diagnostic OBD-II ports.☆315Updated 9 months ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆47Updated last month
- Standalone ECU designed for Speeduino and RusEFI firmware.☆52Updated last year
- Arduino Uno + Seeed Studio CANBUS + BMW M57 diesel☆46Updated 4 years ago
- An Arduino based LINBUS stack and signal interceptor/injector.☆200Updated 6 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- ESP32 based CAN development board☆182Updated 3 years ago
- Arduino Due solution for adding vin-coded modules to BMW cars☆64Updated 7 years ago
- DIY BLE device for RaceChrono, currently supports reading data from the CAN bus☆119Updated 8 months ago