indeterminatedesign / DynamicBalancerLinks
I came up with a design for a 3D printed Dynamic Spin Balancer using an ESP32, an MPU6050 and a hall sensor to help balance out my wheels. Hopefully you all find it useful and maybe someone out there can take the development even further.
☆13Updated 3 years ago
Alternatives and similar repositories for DynamicBalancer
Users that are interested in DynamicBalancer are comparing it to the libraries listed below
Sorting:
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated 11 months ago
- ☆24Updated 4 years ago
- Porting the great SMC3 servo motor controller by Elm Chan to an ATmega328☆17Updated 6 years ago
- Serial port emulation over CAN bus☆30Updated 3 years ago
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆27Updated last year
- Automated device to open and close curtains using ESP32 with Alexa control - Arduino Framework☆10Updated 4 years ago
- Home made cheap brushed ESC☆26Updated 5 years ago
- ☆16Updated 11 years ago
- ☆22Updated 8 years ago
- Vesc UART <-> Esp32 Wifi bridge☆16Updated 5 years ago
- Arduino library for closed loop control of a stepper motor with an encoder.☆24Updated 5 years ago
- A combined frame and 4in1 brushless ESC running BLHeli_s with 16mm hole spacing☆11Updated 7 years ago
- External Stepper Motor Driver☆15Updated 5 years ago
- Motorized solder paste dispenser☆27Updated 2 years ago
- Work in progress. Single ESP32 monitoring and balancing multiple cell Li-Ion battery.☆23Updated 3 years ago
- ☆25Updated 11 months ago
- Simple django project to allow converting gerber files to 3d printable scad solder stencils☆11Updated 9 years ago
- Position control of DC motors☆12Updated 5 years ago
- This motor driver is designed to be interfaced from a host microcontroller by I2C and be able to control the motor with a PID autonomousl…☆33Updated 2 years ago
- Testbed code for the Swarm Drive (ESP32 based BLDC motor driver board)☆31Updated 4 years ago
- A CNC controller to use and test Grbl_ESP32☆79Updated 4 years ago
- This is external programming for ESP32-Cam that you can simple attach it for easy upload your code to ESP32-Cam☆36Updated 3 years ago
- LinuxCNC configuration with EtherCAT Servo Drives Leadshine EL8 and some Beckhoff IO Modules☆37Updated last year
- ☆29Updated 3 years ago
- An app to preview incoming data from the Camsense® X1 LIDAR Scanner.☆13Updated 5 years ago
- ☆12Updated 6 years ago
- Open source I2C based datalogger. The bigger, better cousin to the original serial OpenLog.☆24Updated 2 years ago
- Low Cost DIY Laser XY Scanner, Cutter, or Engraver☆41Updated 9 months ago
- PID Controller using RTOS timers, based on Brett Beauregard's blog posts☆20Updated 5 years ago
- Brushed motor firmware for Brushless ESCs☆28Updated 5 years ago