ThingEngineer / Laser-XY-ScannerLinks
Low Cost DIY Laser XY Scanner, Cutter, or Engraver
☆41Updated last year
Alternatives and similar repositories for Laser-XY-Scanner
Users that are interested in Laser-XY-Scanner are comparing it to the libraries listed below
Sorting:
- An OpenPnP compatible SMT pick and place machine with linear rails based on Anthony Webb's build on hackaday.io.☆13Updated 9 years ago
- A CNC controller to use and test Grbl_ESP32☆79Updated 5 years ago
- Closed loop servo control for stepper motors☆10Updated 9 years ago
- ESP8266 Websocket<>Serial Bridge for LW3☆15Updated 7 years ago
- Home made cheap brushed ESC☆27Updated 5 years ago
- ☆17Updated 11 years ago
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆27Updated last year
- Firmware for 3 Phase BLDC controller☆41Updated 5 years ago
- Simple RPM-Meter☆57Updated 3 years ago
- Hardware design for a 3 Phase BLDC controller☆56Updated 6 years ago
- It is compatible with standard stepper motor diver, cnc or GRBL shield, direct replacement of X-Y stepper motors.☆28Updated 6 years ago
- 4 axis CNC, 3D, Laser Controller☆65Updated last year
- Micro Robot Arm with ESP32 and 28BY-48 12V steppers☆82Updated 6 years ago
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated last year
- Firmware for Arduino DRO with 4 Axis, Tachometer, Touch Probe (http://www.rysium.com/rysium.docs/)☆11Updated last year
- Open Source Brushless DC Servo☆13Updated 6 years ago
- This motor driver is designed to be interfaced from a host microcontroller by I2C and be able to control the motor with a PID autonomousl…☆33Updated 3 years ago
- Generate test patterns for laser galvanometer☆36Updated 3 years ago
- A DIY Mach4 MPG Handwheel (for controlling a CNC Machine) using an ESP32 development kit.☆17Updated last year
- ☆59Updated 4 years ago
- The Little Stick Welder with Big Features.☆43Updated 4 years ago
- 2D actuator☆31Updated 6 years ago
- Project for building a cheap galvo laser system using Stepper motors and widely available parts.☆56Updated last year
- Semi-automatic passive printable/castable feeder for LitePlacer☆59Updated 5 years ago
- RAMPS Servo Board. Replaces the X and Y stepper drivers on a RAMPS CNC control board with two channel DC motor quadrature encoder control…☆22Updated 8 years ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆54Updated 4 years ago
- Telnet to Serial bridge for LaserGRBL☆53Updated 8 years ago
- ESP32_CAM meets Etch-A-Sketch => Etch-a-Selfie☆12Updated 6 years ago
- Tiny Robot with PCB Motor☆21Updated 3 years ago
- Put a camera above your CNC machine. Put charuco markers on CNC rails. Program will overlay your G code onto the camera image, showing …☆33Updated 3 years ago