gregyedlik / handshake
Understanding the challenge-response process used in Bosch e-bike systems, with the aim of producing compatible BMS boards.
☆40Updated 2 years ago
Alternatives and similar repositories for handshake:
Users that are interested in handshake are comparing it to the libraries listed below
- CAN_Interface for ESP32 (Cannelloni Protocol)☆52Updated 3 years ago
- DisplayPort to Ipad 3/4 panel adapter☆64Updated last year
- UCAN is an open source USB-to-CAN interface board, based on STM32F072 and candleLight open source firmware, and supports linux/win/mac mu…☆27Updated last year
- Battery Tester, Milliohm Meter, Software☆23Updated last year
- CH330 breakout board☆26Updated 2 years ago
- Hardware circuit diagram for interfacing to the Webasto WBUS interface from a PC/Arduino☆22Updated 5 years ago
- CAN Bus logger with SD card implemented using ChibiOS☆68Updated 5 years ago
- A simple car simulator PCB for testing EVSE.☆48Updated 2 years ago
- Arduino software for controlling Webasto ThermoTop heaters over its custom WBUS protocol☆27Updated 8 years ago
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆52Updated last year
- ☆12Updated 2 years ago
- Open Source CAN bus Analyser and Simulation Software☆60Updated 4 years ago
- ☆40Updated last year
- With these schematics and PCB's, it's possible to create a 230V AC 4KW inverter. The main processor is based on Arduino Nano, with help f…☆58Updated 2 years ago
- Optimized OpenSource firmware for TongSheng TSDZ2 mid drive ebike motor☆11Updated last year
- ☆95Updated 3 years ago
- S06S 250W Torque Simulation Sine Wave Controller☆14Updated 7 years ago
- ESP8266 reflow controller☆35Updated 2 years ago
- SmuView is a GUI for sigrok that supports power supplies, electronic loads and all sorts of measurement devices like multimeters, LCR met…☆134Updated last year
- Open-Source firmware for the ZPB30A1 electronic load (WIP)☆49Updated 6 years ago
- MPPT charge controller with HS load switch and CAN bus☆82Updated 3 years ago
- This is an Arduino library providing an emulation of the CAN communication protocol of the BMS (battery management system) on a Renault T…☆82Updated last year
- Arduino project to control webasto heater via W-bus☆42Updated 6 years ago
- Open hard- and software solar maximum power point tracker☆83Updated 7 years ago
- Retrieve battery diagnostic data from your smart electric drive EV.☆53Updated 2 years ago
- Programming the Hella Universal turbo actuator☆12Updated 4 years ago
- open source Panasonic/Flyer eBike/Pedelec Motor Controller☆14Updated 5 years ago
- Remove the Speed limit of a Bosch middle engine☆21Updated 4 years ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆63Updated last year
- A DIY soldering controller for JBC T245 handle & C245 tips☆40Updated last year