sabsteef / BoschEbikeSpeedupLinks
Remove the Speed limit of a Bosch middle engine
☆21Updated 5 years ago
Alternatives and similar repositories for BoschEbikeSpeedup
Users that are interested in BoschEbikeSpeedup are comparing it to the libraries listed below
Sorting:
- A BTLE display for your Xiaomi M365 Scooter, based on the Nordic Semiconductor nRF52832 SoC.☆27Updated 6 years ago
- Firmware for the ESP32 add on Board☆12Updated last year
- SMBUS analyzer tool using an Arduino Pro Mini for Smart Batteries that use the Smart Battery System Specification.☆30Updated 5 years ago
- Xiaomi M365 BMS Monitor ESP32BLE☆16Updated 3 years ago
- Arduino project to control webasto heater via W-bus☆44Updated 6 years ago
- ☆41Updated 5 years ago
- The Ultimate Mobile (Android/IOS) Display and Configuration Tool for Bafang E-Bike motors.☆20Updated last year
- Understanding the challenge-response process used in Bosch e-bike systems, with the aim of producing compatible BMS boards.☆41Updated 3 years ago
- Firmware for Roxie, a device for electric vehicles that displays data read from VESC based speed controllers.☆20Updated 3 years ago
- Optimized OpenSource firmware for TongSheng TSDZ2 mid drive ebike motor☆11Updated last year
- M365 esc recover using stlink☆45Updated last year
- Decode tire pressure monitoring system TPMS BLE 433MHz CC1101 ESP8266 ESP32☆81Updated 2 years ago
- Monitor the status of your Smart electric drive EV with Blynk☆27Updated 2 years ago
- Texas Instruments BQ25896 driver for ATMEGA MCUs☆16Updated 8 months ago
- CAN Logger based on CAN32 board (ESP32 board with CAN-Bus)☆18Updated 5 years ago
- Allows: read firmware via BLE, restore and patch the original firmware, ...☆10Updated 9 months ago
- Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display☆29Updated 7 months ago
- Vesc UART <-> Esp32 Wifi bridge☆16Updated 5 years ago
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- A ESP32 based interface between CAN-bus and IoT environments.☆41Updated 2 years ago
- This is simple half duplex radio communication device built with CC1101 module and Arduino Pro Micro (3.3V / 8MHz) using SmartRC library☆18Updated 2 years ago
- ☆80Updated 10 months ago
- Bridge between Wifi and CAN. Minimal variant of the ESP32RET. Using ESP32s3☆28Updated 7 months ago
- EBike / EScooter app developed in CircuitPython, to control a motor by sending commands to VESC motor controller☆66Updated last month
- ☆20Updated 3 years ago
- ☆28Updated last year
- ES-200 Scooter Unlocker☆73Updated 3 years ago
- UCAN is an open source USB-to-CAN interface board, based on STM32F072 and candleLight open source firmware, and supports linux/win/mac mu…☆29Updated 2 years ago
- S06S 250W Torque Simulation Sine Wave Controller☆14Updated 7 years ago
- An open source Arduino ESP32 MPPT Charger firmware equipped with charging algorithms, WiFi, LCD menus & more!☆36Updated 2 months ago