fransschreuder / DeEmbedLinks
Read TouchStone files (S-Parameters) and plot them. Also calibrate them using Short-Open-Load / Through-Isolation calibration files
☆16Updated 8 years ago
Alternatives and similar repositories for DeEmbed
Users that are interested in DeEmbed are comparing it to the libraries listed below
Sorting:
- a simple and cheap vector network analyzer, including support software☆160Updated 5 years ago
- 4 port eCal module☆101Updated last month
- Under development open hardware microwave vector network analyzer☆195Updated last year
- Vector Network Analyzer based on the STM32F103C8T6 bluepill☆86Updated 4 years ago
- 1MHz to 6GHz USB based vector network analyzer☆147Updated 4 years ago
- experimental open hardware e-field and h-field probes and LISN☆26Updated 2 years ago
- 5MHz to 2.1GHz RF Synthesizer with modulation capability☆52Updated 2 years ago
- Low-noise oscilloscope power rail probe☆82Updated 3 weeks ago
- Jim Williams Pulse Generator for oscilloscope rise time measurements☆29Updated 4 years ago
- Second version of my 1MHz to 6GHz USB based vector network analyzer☆16Updated 4 years ago
- Simple SCPI parser for Arduino☆105Updated last year
- Work towards an open-source multi-GHz sampling oscilloscope design☆36Updated 5 years ago
- A tiny 1.3 GHz FET Probe☆31Updated 3 years ago
- An experimental GPSDO using an STM32 MCU and a u-blox Neo-M8 GNSS module.☆88Updated 3 years ago
- Prototype time domain reflectometer/sampling oscilloscope☆52Updated 6 years ago
- EMC near-field probe designs☆33Updated 4 years ago
- PCB KiCAD project files☆77Updated 11 years ago
- Second version of homemade 30 MHz - 6 GHz VNA☆239Updated 7 months ago
- Vector Network Analyzer 10 KHz - 180 MHz☆25Updated 7 years ago
- VNA using audio input☆28Updated 5 years ago
- A 0.01Hz-1+MHz low noise amplifier☆26Updated last year
- Hamradio SDR☆57Updated 8 years ago
- It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.☆44Updated 6 years ago
- Si5351 lib for STM32☆63Updated 3 years ago
- Complete antenna simulations from rapid design in FreeCAD and simulate using openEMS☆31Updated 4 years ago
- RF Signal Generator with filtered outputs, modulation features☆15Updated 4 years ago
- ☆189Updated 8 years ago
- Firmware for http://hackaday.io/project/6872-gps-disciplined-ocxo☆34Updated 3 years ago
- 2GHz single-ended active probe design☆135Updated last year
- Sub-nanosecond time interval counter☆40Updated this week