csreades / AutothermDieselRepeaterLinks
A set of scripts to integrate autotherm diesel heater into home assistant.
☆37Updated 2 years ago
Alternatives and similar repositories for AutothermDieselRepeater
Users that are interested in AutothermDieselRepeater are comparing it to the libraries listed below
Sorting:
- Monitor your Daikin Altherma / ROTEX heat pump with ESP32☆460Updated last month
- ebusd configuration files☆250Updated 2 months ago
- ESP8266 firmware to read and control EMS and Heatronic compatible equipment such as boilers, thermostats, solar modules, and heat pumps☆313Updated 4 years ago
- Panasonic Aquarea air-water H, J, K and L series protocol decrypt☆332Updated 3 weeks ago
- Controller for HmIP-VdMot actuators☆68Updated 6 months ago
- Growatt ShineWifi modbus with ESPHome code to run native in Home Assistant☆33Updated last year
- ESP8266 and ESP32 compatible firmware to read, interpret and publish data to MQTT from smart electrical meters, both DLMS and DSMR is sup…☆432Updated last week
- Interact with Zehnder Comfoair with esp32☆140Updated 2 months ago
- esphome firmware for esp32_8ch_motor_shield☆56Updated 2 months ago
- ESPHome component to read out DLMS smart meters via M-Bus☆119Updated last year
- Victron Mppt charger ve.direct to esphome node☆385Updated 4 months ago
- ESPHome configuration to drive Zehnder ComfoAir devices.☆73Updated last week
- Interact with Zehnder Comfoair Q using ESPHome and Home Assistant☆65Updated 2 weeks ago
- ESP8266 based smart meter (SML) to MQTT gateway☆320Updated 2 years ago
- Firmware replacement for Growatt ShineWiFi-S☆412Updated 3 months ago
- This project emulates Smart Meter devices for Marstek storages such as the B2500, Marstek Jupiter and Marstek Venus energy storage system…☆226Updated this week
- Use official Victron BLE endpoint for fetching data from Victron devices via Bluetooth LE via ESPHome.☆352Updated 3 weeks ago
- Integration for Home Assistant to fetch data from the victron gx device via modbusTCP☆291Updated last month
- ☆35Updated 3 years ago
- ESP32 firmware to read and control EMS and Heatronic compatible equipment such as boilers, thermostats, solar modules, and heat pumps☆862Updated this week
- Open-source ESP32 project that connects your Hörmann garage door to Home Assistant or any MQTT-based smart home system. It provides full …☆124Updated this week
- Monitor and control Daikin/Rotex Altherma heat pumps from Home Assistant directly via the 2-wire P1/P2 thermostat interface. Also enables…☆424Updated 2 months ago
- ☆95Updated 2 years ago
- An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)☆111Updated 5 months ago
- Software for an esp8266 nodemcu to read data from APS inverters.☆143Updated 3 months ago
- ESPHome custom component for reading P1 data from electricity meters.☆320Updated 10 months ago
- Homeassistant Automation und Sensoren Templates für Akkusteuerung über SMA Smart Energy☆52Updated last month
- Local/LAN Tibber Pulse IR/Bridge Integration for Home Assistant. My Tibber invitation Link: https://invite.tibber.com/6o0kqvzf (Code: six…☆206Updated this week
- Control Hörmann doors directly via MQTT☆126Updated 4 months ago
- go-eCharger integration for Home Assistant using the MQTT API☆116Updated this week