cfriesicke / inkscape-schematic-symbolsLinks
Collection of Inkscape svg files for drawing schematics and RF/microwave block diagrams
☆19Updated 10 years ago
Alternatives and similar repositories for inkscape-schematic-symbols
Users that are interested in inkscape-schematic-symbols are comparing it to the libraries listed below
Sorting:
- Ultra low-noise current controller for laser diodes☆19Updated 5 years ago
- openEMS High-level layer☆19Updated 2 months ago
- RF electronics engineering ecosystem☆29Updated 3 years ago
- Simple GUI plugin for FreeCAD to export current model for EM simulation in OpenEMS☆89Updated last year
- Wide Bandwidth low noise amplifier 20Hz-20MHz 20/40dB☆11Updated 5 years ago
- This is a open source hardware (and software) RF Signal Generator using readily available off the shelf-components.☆11Updated 5 years ago
- Photodiode transimpedance amplifier, on a one inch diameter circular PCB☆17Updated last year
- Import Hyperlynx Boardsim files to openEMS, an open source 3D full-wave electromagnetic field solver.☆14Updated 4 years ago
- Main EAGLE PCB design file repo.☆16Updated 3 years ago
- OpenEMS simulation of VNA calibration standards☆10Updated 2 years ago
- ☆35Updated 8 months ago
- KiCad schematics and ngspice simulations originally published by Holger Vogt☆48Updated last year
- KiCad plugin to determine the parasitic properties of the printed tracks in the PCB layout.☆35Updated last month
- FPGA-Based DIY Function Generator☆51Updated 4 years ago
- TIASim - Transimpedance Amplifier Simulation☆23Updated 4 months ago
- experimental open hardware e-field and h-field probes and LISN☆26Updated 2 years ago
- ☆22Updated last year
- A 0.01Hz-1+MHz low noise amplifier☆21Updated last year
- Modular differential probe (DEDP-100)☆28Updated 3 years ago
- It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.☆41Updated 5 years ago
- Python module + RP2 firmware for direct hardware control without compilation☆29Updated last week
- A repository of information and source files for toolflow-supported hardware☆31Updated 2 years ago
- ERASynth Documentation☆18Updated 5 years ago
- Complete antenna simulations from rapid design in FreeCAD and simulate using openEMS☆28Updated 4 years ago
- A Python wrapper to the OpenEMS FDTD solver with Kicad footprint generation☆86Updated last year
- Simple wrapper for the Prologix GPIB-to-Ethernet adapter.☆30Updated 4 years ago
- An open source instrument control and data acquisition framework☆18Updated 5 months ago
- EDA component libraries☆19Updated 7 years ago
- Conecting the Litefury FPGA accelerator to Raspberry Pi 5 over PCIe gen2 x1☆29Updated last year
- High-level python interface to OpenEMS with automatic mesh generation☆87Updated 10 months ago