bugblat / sniffer
support code for the Bugblat USB sniffers
☆15Updated 3 years ago
Alternatives and similar repositories for sniffer:
Users that are interested in sniffer are comparing it to the libraries listed below
- Raspberry Pi Pico voltage glitcher.☆26Updated 2 years ago
- ChipJabber-Unplugged does new-school attacks with old-school logic.☆12Updated 4 years ago
- flashrom compatible serprog firmware for the Pico Debug'n'Dump☆25Updated last year
- My KiCAD libraries☆15Updated 2 months ago
- SPI flash MITM and emulation (QSPI is a WIP)☆20Updated 3 years ago
- Mini PCI Express GPS module☆10Updated 3 years ago
- Files and documentation for Pico-Dirty-Blaster Workshop☆17Updated 8 months ago
- Reverse Engineering of the Cisco HWIC-3G-CDMA PCB☆40Updated last year
- Extracting bits from Microscope images of ROM Constants, and disassembling them into readable 8051 assembly code☆22Updated 3 years ago
- An example showing how to develop basic firmware for the Pico Debug'n'Dump☆15Updated last year
- Saleae ARM Serial Wire Debug (SWD) Analyzer☆19Updated last year
- USB-C ports made from a flex PCB and an ATtiny84A☆39Updated 3 years ago
- Reciprocal frequency counter with Pi Pico☆13Updated 2 years ago
- Utilizing fl2k (FL2000-based USB3-SVGA video adapter) as a bench signal generator with TUI☆26Updated 2 years ago
- carrier board for using the seeduino xiao (or xiaorp2040, adfruit qt py, qt py 2040) for jtagulating and implanting☆25Updated 2 months ago
- SPI NOR flash programmer using Blue Pill (STM32 development board)☆18Updated 6 years ago
- FX2 replacement for USB-Blaster from http://fpga4u.epfl.ch/wiki/FX2☆22Updated 10 years ago
- Low-bitrate open source speech codec for Raspberry Pi RP2040☆38Updated 2 years ago
- Fork of CH55x-USB-Blaster firmware that runs on cheap USB Blaster I got on Amazon☆30Updated 2 months ago
- Forked from http://git.osmocom.org/osmo-fl2k . Turns FL2000-based USB 3.0 to VGA adapters into low cost DACs.☆15Updated 4 years ago
- Qt-based software for USB2Sniffer☆31Updated 2 years ago
- Firmware for the FX2 which emulates the FTDI serial chips (including MPSSE support).☆13Updated 6 years ago
- Deprecated, use 'wlink' instead. Command line tool to switch WCH-LinkE modes between DAP and RV from host.☆10Updated 3 months ago
- Simple peripheral library for CH55x microcontrolles☆16Updated 3 years ago
- ☆25Updated 4 years ago
- Minimal UART client in Golang that dumps LPC1343 chips that are locked at CRP1.☆20Updated 4 years ago
- Programming software for Microchip PIC chips using FTDI FT232RL USB-to-serial converters☆33Updated 5 years ago
- Outdated. See https://github.com/saleae/jtag-analyzer for the official Saleae JTAG Analyzer☆12Updated 6 years ago
- Test Interface for Multiple Embedded Protocols☆22Updated 4 years ago
- ECP5 FPGA DEV BOARD☆9Updated 3 years ago