bonafid3 / CoilWinder
3D printed coil winder using ESP32 & Qt for host app
☆24Updated last year
Alternatives and similar repositories for CoilWinder:
Users that are interested in CoilWinder are comparing it to the libraries listed below
- Coil Winder (Open Source Making)☆18Updated 2 years ago
- Multiple compiled versions for different boards & machines (under releases)☆58Updated 2 years ago
- List of controllers supported by grblHAL☆41Updated last week
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆48Updated 3 years ago
- ☆54Updated last year
- Arduino based THC that read plasma cutter voltage and send Up and Down signals to Plasma Torch Actuator to adjust voltage to target value…☆43Updated 4 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆75Updated 9 months ago
- ESP32 DIY Digital Readout☆91Updated 5 years ago
- Marlin Laser working version with RAMPS Generic config☆20Updated 4 years ago
- Tiva C BoosterPack for GRBL MPG/DRO☆46Updated last year
- A premium-quality 3D printer control board by Aus3D.☆40Updated 3 years ago
- Offline controller for CNC with GRBL 1.1☆68Updated 4 years ago
- ☆74Updated 2 years ago
- The G-EDM is a 4in1 electrical discharge machine that supports sinker EDM, EDM engraving, EDM drilling and Wire EDM operations. In the fu…☆49Updated 6 months ago
- CNC Base for Blue Pill☆16Updated 6 years ago
- Firmware for the 0816 automatic 3d printed smt feeder for OpenPnP.☆34Updated 2 years ago
- Low-cost and simple GRBLHAL to MACH3 BOB bridge for Raspberry Pi Pico☆27Updated 10 months ago
- 3D printer control board based on ESP32,support 8 Driver motors.☆74Updated 2 years ago
- A Grbl_ESP32CNC Controller for MPCNC☆87Updated 2 years ago
- A powerful 32-bit 3D printer control board.☆70Updated 4 years ago
- Expatria Technologies GRBLHAL Breakout board for PrintNC☆29Updated last year
- ☆18Updated 5 months ago
- The RAMPS 1.6 is the second RAMPS iteration released by BIGTREETECH. It replaces the original green power connector with a pair of screw …☆87Updated 5 years ago
- A CNC controller to use and test Grbl_ESP32☆76Updated 4 years ago
- Driver overview☆32Updated 2 weeks ago
- GRBL ported to ESP8266, using up to 8 axis. No arduino involved☆58Updated 2 years ago
- Smart Effector for delta printers.☆25Updated last month
- All the mechanics of the BCN3D Sigmax R19 3D Printer.☆42Updated 5 years ago
- The closed-loop drive is to feedback the rotation angle of the stepping motor to the control panel, compare the distance that needs to be…☆25Updated 5 years ago
- MKS TFT32/28 alternative firmware☆68Updated 7 years ago